5-28) Determine the tension in each cables, sag Yc, and the largest mass, M, that can be sustained by the cables if th ximum tension allowed is 650 N. 27. What is the largest mass, 3.75 m 1.5 m 1.5 m M, that can be sustained? A 143 N

Q: At what angle theta will both boxes begin to slide.

A: m1=65lbs = m2

Q: Replace the loading on the frame by a single resultant force. Suppose that F = 400 N, a = 0.5 m, and…

A:

Q: Determine the magnitude (N) of the force in member BC  if  F=287N , a=0.44m, b=1.97m, r=1.71m and…

A:

Q: Block A has a mass of ma = 59.0 kg and rests on a flat surface. (Figure 3)The coefficient of static…

A:

Q: Answer the following questions include directions: 1. What is the magnitude and direction of the…

A:

Q: O AEd It vec B, = N Submit Request Answer Part E- Part E There exists a point of zero shear between…

A:

Q: Determine the smallest coefficient of static friction at both A and B needed to hold the uniform…

A:

Q: 5.119 Water is to be pumped from the large tank shown in Fig. P5.119 with an exit velocity of 6 m/s.…

A:

Q: 500 lb 600 lb · ft A B -5 ft - -5 ft -5 ft

A: Forces and moments generated in any member depend upon the type of support and type of loading…

Q: 1.0p 1i 1860N 0,1 003 ab Answer EMC = De balk van 148 kg wordt gedragen door twee klemmen. Eén zo'n…

A: given; a=0.1mb=0.03m mass(m)=148kgweight(w)=mg                   =148*9.81…

Q: Replace the three forces acting on the shaft by a singl resultant force. Suppose that F1 = 650 lb,…

A:

Q: eplace the loading on the frame by a single resultant orce. Suppose that F = 300 N ‚F2 = 500 N, 3 =…

A:

Q: Question 2 Find the value of a (in mm) for which the magnitude of the reaction at B is equal to 800…

A:

Q: Show full work. 3-150 In an article on tire maintenance, it is stated that tires lose air over time,…

A: Pressure loss from tyre per year = 90 kPaThe beginning tyre pressure = 220 kPa (guage)

Q: In order to experimentally determine the moment of inertia Ig of a 4-kg connecting rod, the rod is…

A:

Q: What is the Moment–Curvature Relationship?

A: Moment curvature relationship is used to determine the load and deformation behavior for a concrete…

Q: Question 4 Part A If 0 = 27° and F = 5 kN , determine the magnitude of the resultant force acting on…

A: Given -

Q: What would be the resultant force F of the triangular distributed load and its location d measured…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.