An air compressor, as shown in the figure, compresses air from atmospheric pressure (100 kPa) and temperature of 280 K to a discharge condition at a pressure and temperature of 600 kPa and 400 K, respectively. The mass flow rate of the air entering the compressor is 1 kg/s. The compressor losses heat through its walls at a rate of 40% of the total required power running the compressor. Assume that the changes in both kinetic and potential energies are negligible. The absolute value of the power consumed by the compressor is ...kW?

Q: Q.3. Air flows steadily adiabatically through a pipe with a constant cross-sectional area. Air is…

A:

Q: an insulated piston-cylinder assembly initially at constant pressure of 250 kPa There is 4 L of…

A: Given data:   Pressure of piston-cylinder assembly = 250 kPa Volume of saturated liquid water = 4 L…

Q: 1 mole of steam is pressurized at 5 bar in a horizontal cylinder equipped with a frictionless…

A: Note: Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: A throttling steam calorimeter is an instrument used for the determination of the quality of wet…

A:

Q: True or False: 1. In a continuous flow process, the mass flow rate of fluid entering the system is…

A: Answers:1). True Explanation: In a continuous flow process, mass is conserved. The mass flow rate of…

Q: Find the specific work done in a Rankine cycle if the steam supplied at 650 kPa and 0.9 dry and the…

A: The given parameters are:Pressure at which steam is supplied (P1) = 650 kPaDryness fraction (x) =…

Q: a- the volume flow rate of air at the inlet b- the mass flow rate of air at inlet and at exit c- the…

A: HGGHH

Q: Steam flows in a Schedule 40, 6 (in) (Internal Diameter-6.065 in) pipe 1000 ft long, with roughness…

A: Given that  For schedule 40d1  =6 in =6 x 0.0254 = 0.1524 m L = 1000 ft =  10003.28084 =304.8 m m  =…

Q: If the suction pressure of compressor equal to discharge pressure then the work of compression for…

A:

Q: Refrigerant 134a flows through a horizontal tube with an inside diameter of 5 cm. The refrigerant…

A: Given: The inside diameter of the horizontal tube=5 cm quality at which the refrigerant enters=0.1…

Q: Find the average power of the paddle wheel in kW During a constant-pressure process in a cylinder…

A: The average power for the wheel of a paddle is to be determined in kW.

Q: Q1: Air enters a diffuser at 200 m/s with a pressure of 85 kPa and a temperature of -20°C. It leaves…

A: At T  -20 ( 455 R)  H1 = 107 btu/lbm                          [From ideal gas table]  FRom first law…

Q: Compressed air at room temperature (295 K) is contained in a 20-L tank at 2 bar. The valve is opened…

A:

Q: Steam flows at steady state through a converging, insulated nozzle, 25 cm long and with an inlet…

A: Given thatl =25 cm =0.25 m d = 5 cm =0.05 mP1 = 700 KPaT1  = 325 CV1 = 30 m/sP2 = 350 KPaT1  =240 C

Q: An adiabatic steady-state turbine is operated reversibly to generate energy. The inlet to the…

A: Energy is generated by expansion of steam through a reversible, adiabatic turbine.

Q: 3) Steam is produced in a boiler using liquid water as the feed. The boiler operates at 100 kPa. The…

A: Given: Inlet Water Temperature  = T1  = 40 oC  = (40+273) K  = 313 K  Outlet Steam Temperature  = T2…

Q: Air enters an adiabatic turbine at 600 kPa and 1000oC. The exit pressure of the air is 50 kPa.…

A: The temperature at the exit of the adiabatic turbine is to be calculated along with the amount of…

Q: It is proposed to design and develop a Rankine cycle Steam Power Plant in which steam at 80 bar and…

A: Note: Since we are entitled to answer only 3 sub-parts, we’ll answer the first 3 subparts. Please…

Q: A cylindrical vessel with 2 m diameter and 4 m length initially contains R-134a at 1 MPa, 100 degree…

A: Given Data  Diameter of the vessel (D) = 2m Legth of the vessel (L) = 4 m Hence , the volume of the…

Q: Water in a tank at 87OC is pumped into a second tank that is located 20 m above the initial tank at…

A: Temperature of water in tank 1 = 87 0C Mass flow rate = 6.5 kg/s Work done by the pump = 500 kJ/s…

Q: Problem 1: One kg of water is placed inside a well-insulated piston. The external pressure PE is…

A: External pressure= 10 MPa Initial temperature of water= 20 0C Final temperature of liquid = 400 0C…

Q: A rigid tank  filled with water is divided into two chambers by a membrane. the membrane is a…

A: A membrane is used in a rigid tank of water to separate it into two chambers ‘a’ and ‘b’.   Chamber…

Q: Determine the rate of condensation of steam in Kg/h.

A: Properties at saturated steam pressure of 84.55 kpa or 0.8 bar Tsat = 366.66 K ρv = 0.479 kg/m3 hfg…

Q: A rigid tank is divided into two equal sections by a diaphragm. Initially, one of the sections has a…

A:

Q: A horizontal coil of water is circulated through it, which is heated from the outside by…

A: Given: The inlet pressure of water=200 kpa The outlet pressure of water=100 kpa The inlet…

Q: A gas refrigeration system using air as the working fluid has a pressure ratio of 5 (see Fig. Q 1).…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: Which of the following statement is true for the heat transfer? A It is the form of energy that can…

A:

Q: A Compressor compresses the air at 112 kPa and 300 K to 415 kPa and its inner diameter is 0.021 m.…

A:

Q: A compressor receives air at 101.3 kPa at a steady rate of 0.5 kg/s and delivers at 700 kPa. At the…

A: Given mass flow rate of air into compressor, v= 0.5 kg/s inlet velocity of air V1=6 m/s exit…

Q: The pressure is reduced to 872 kPa by cooling the steam at 4 MPa and 548 K at a fixed volume. The…

A: Total change in the entropy is asked. Given: P1=4×106 PaP2=872×103 PaT1=548 KT2=288 KSpecific heat…

Q: At the commencement of compression in the reciprocating compressor of a refrigeration plant the…

A: Given:The compressor follows  at To find the work done, Internal energy and heat transfer through…

Q: Assume that nitrogen is available in a storage tank at 2 MPa and 210 K. On the following chart, show…

A: Solving first 3: a) An expansion valve is connected to this tank that drops the fluid (i.e.,…

Q: 1. When a system absorbs heat, a part is stored within the system as the energy of internal motions…

A:

Q: Q1. Steam turbine is a device that extracts thermal energy from pressurized steam and us to do…

A: