Find the average power of the paddle wheel in kW During a constant-pressure process in a cylinder air expands at 400 kPa from 10 L to 30 L in volume. The device is insulated and a paddle wheel does shaft work to the system. If the internal energy change during this process is 15 kJ, and the process lasts 10 seconds,  Neglect energy loss associated with the paddle wheel.

Q: 4. An experimental test rig is used to examine two-phase flow regimes in horizontal pipelines. A…

A: A two-phase flow regimes in horizontal pipelines is given with the following data,the temperature of…

Q: Mass flow rate of the water along the length of the hose: [Select] Velocity of the water along the…

A:

Q: 12.) An individual running on a treadmill machine generated an average power of approximately 0.27…

A:

Q: A transmission case measures W = 0.30 m on a side and receives a power input of P; = 150 hp from the…

A:

Q: Find the total capacitances 00 4

A: Total capacitance in series 1Cs = 1C1+1C2 1Cs=1100+13301Cs= 330 + 10033000 1Cs= 43033000Cs =…

Q: Air flows with a velocity of 6 m/s across a 20 cm? plate at 50 kPa and 300 K. An electrical heater…

A:

Q: Find the specific work done in a Rankine cycle if the steam supplied at 650 kPa and 0.9 dry and the…

A: The given parameters are:Pressure at which steam is supplied (P1) = 650 kPaDryness fraction (x) =…

Q: #2: Your boss tells you that water at 68 F is flowing in a cooling tower loop at a rate of 35 gpm,…

A: Disclaimer: Since you have asked multiple question, we will solve the first question for you. If you…

Q: Calculate the capacitance of a parallel-plate capacitor whose plates are 20cm x 3cm and are…

A: Area A = 20 x 3 cm = 20 x 3 x 10-4 m Distance between plates d= 1 mm=1 x 10-3 m New capacitance c'…

Q: 4.36. A steady-flow water power plant has the following inlet and outlet conditions: Pressure, psig…

A: Given data for steady flow water plant are as follows:   Inlet Outlet Pressure, psig 0 0…

Q: Chapter 5: Water (density is 1000 kg/m) is in the cylindrical tank. When the valve at B is 1)…

A: In fluid mechanics, according to Swiss mathematician and physicist Daniel Bernoulli, the total fluid…

Q: A rigid, stationary, short evacuated tank is adiabatically filled with gas from a horizontal,…

A:

Q: Which of the following is the rate of heat transfer unit 1. Watt 2. Pascal 3. Joule 4. None of these

A: Heat transfer is the transfer of heat due to modes of heat transfer like conduction, convection and…

Q: 4. (20 points) Water (25°C) flows at 4.5 gpm (gpm is gallons per minute) in the system shown below.…

A: a) flow rates will be same along the pipe assuming no change in density.   1 gpm =0.00006309 m3/s…

Q: A water pipe is connected to a double-U manometer as shown in Figure below at a location where the…

A:

Q: Determine the compressor work input required to compress saturated liquid water isentropically from…

A: The work required to compress the liquid water which is saturated at the isentropic conditions is to…

Q: For the configuration shown in Figure 1, calculate the weight of the piston if the gage pressure…

A: