An abc-sequence, three-phase, 4-wire, 380-V supply is connected to an unbalancedload having phase impedances of: Za = 8 + j6 Q, Z = 8-j6 Q and Zc = 5 Q. Impedanceof the neutral wire is 0.5 + j1 2. Line impedance is 1 + j2 0 per phase. Find the value ofthe neutral current in polar form.

An abc-sequence, three-phase, 4-wire, 380-V supply is connected to an unbalanced load having phase impedances of: Za = 8 + j6 Q, Z₂ = 8j6 Q and Zc = 5 Q. Impedance of the neutral wire is 0.5 + j1 Q. Line impedance is 1 + j2 0 per phase. Find the value of the neutral current in polar form.

An abc-sequence, three-phase, 4-wire, 380-V supply is connected to an unbalanced load having phase impedances of: Za = 8 + j6 Q, Z₂ = 8j6 Q and Zc = 5 Q. Impedance of the neutral wire is 0.5 + j1 Q. Line impedance is 1 + j2 0 per phase. Find the value of the neutral current in polar form.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: In the transformer circuit shown, find the primary current I1 (Polar form, in Aprms). Refer all…

Q: In the circuit given in Figure 2, voad(t) = /2 -80 cos(4t)V a) Express each circuit element in…

Q: 7. For the circuit below, calculate the value of Zz for maximum average power transfer to the load.…

A: Calculate the value of Z for maximum average power tyansfer to the load. In addition, deternmine the…

Q: g. Find the power factor of the circuit, and indicate whether it is leading or lagging. h. What…

A: I have explained in detail

Q: P.2-6- By vsing Conplex impedance technique s find The overall Traas fom fun fion for the fellowi ag…

Q: Determine the load currents at 2 0, 14 N, 4 N and 100 Q using Superposition theorem. 2ng 15A 59

Q: Figure Q2(a) shows a positive sequence three phase circuits. Given a line-to-line voltage.…

Q: Use Millman’s theorem and determine the magnitude of the neutral displacement voltage,(Vsn) in the…

A: The Given data is Za=0°18ΩZb=60°12ΩZc=60°30ΩEab=360VVsn=?

Q: An L-R-C series circuit is connected to a 120-Hz ac source that has Vms = 73.0 V. The circuit has a…

A: Given a series LRC circuit, having Resistance, R = 76 Ω Impedance, Z = 119 Ω Voltage, V = 73 V (rms)…

Q: 4- If the magnitude of voltage is v= 10sin(wt+100) and the current is i=5sin(wt+150), so the phase…

A: We need to find phase between voltage and current .

Q: (b) A symmetrical delta-connected 415V three-phase supply is feed to an asymmetrical delta-…

Q: c) A heater with resistance 10 N is driven by an AC voltage source (120 V). For the circuit shown…

Q: QUESTION 2 Two loads are connected in parallel to the supply, the first takes a current of 40 A at a…

A: Current I1 = 40 A lagging at 30⁰Current I2 = 30 A leading at 45⁰Asked to plot the phasor diagram and…

Q: Ex2: Two trausformers A and B are Connected in parallel their impedances in secondary terms are ZA =…

A: two transformers A and B are connected in parallel to a load of (2+j1.5)ohm their impedances in…

Q: For the three-phase network shown in the figure, find the current in each wire and the real power…

A: Evaluating the current in the each phase:

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

Q: 6. A Y-connected load with an impedance of 12 - 15 N per phase is con- nected to a balanced…

A: In this question, we need to determine the voltages , currents and powers in the load. source is…

Q: 3. A three phase source, 4-wire having a per phase voltage of 230V. An unbalanced load is connected…

A: I will appreciate your kind rate. Please assess my answer, and if there is any doubt, do not…

Q: R - 40 X, = 60 Xc - 10 N + UL + Uc e - 70.7 sin 3771 Z,

Q: For the circuit shown, ZL = 50 – j30 N. What component is needed to form impedance ZPFC in parallel…

A: Given V=55∠0° Vf=110 HzZL=50-j30 Ω Calculating admittance of the given circuit…

Q: A balanced three-phase A-connected supply delivers power through a three-phase wire in an industrial…

A: NOTE: Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: Q. 2a) The impedance Zi and Z2 are connected in parallel across 200 V, 50 HZ single phase ac supply.…

Q: Given the circuit below. A U,07t U.077 100-V 3- source b 5260'n 22-30°n Iec 3.1. Determine the…

A: The voltages for given supply is Vab=100∠0°Vbc=100∠-120°Vca=100∠120° The current I is calculated as…

Q: Example23/ Two transformers are designed to match a line having a Z, = %3D 3002, ZR = 75.2 find…

Q: 5.In three-phase transformers, the high voltage star connection is preferred. This is so because in…

A: It is given that:In three-phase transformers, the high voltage star connection is preferred.

Q: Which of the following descriptions IS NOT correct for loads in power systems? A. The purely…

A: capacitive load will deliver reactive power to the grid. so option C is the wrong one

Q: A balanced positive-sequence wye-connected 60-Hz three-phase source has line-to-line voltages of 400…

Q: 2. Given that Vs(t) = 100cos oot volts, f= 50 Hz, R₁ = 100 ohm, R₂ = 200 ohm, RL = 250 ohm, C = 40…

A: In this question, We need to average power across the RL Power P= I2 R Value of R and L for…

Q: Given the circuit below. A 220'n U,07t 100 -v 3-4 source b B U,097$ ICA lạc 22- 30°n Determine the…

A: From the three phase system ..

Q: For the circuit shown, if (ZA = 4+j3) Q, then answer Questions (1-4) A 10020 Vrms Z IB В 1002 120…

A: KIRCHHOFF’S LAW: KCL: The algebraic sum of all currents at a node is zero. Kirchhoff's current law…

Q: A balanced load is connected in star across a 3 phasec415V 50Hz supply. The load consists of a coil…

Q: The voltage between two phases in a balanced three phase-system (4 conductors) is U = 660V. The…

Q: Predict the output when the input three phase signal is given to the circuit shown in figure.3. IA…

Q: 14.20 A load consists of a resistance connected in parallel with a capacitive reactance is taking 20…

Q: a. As an electrical engineer, explain about the power system in Figure Q2 with respect to the…

Q: B Detector B. Detector ww ell

Q: 4.3. Consider 3 ac loads connected across a 240V ac source where: L1 absorbs 10kW at 0.8pf laggin L2…

Q: An AC circuit with R, Land C in parallel, has the following branch currents. Resistive branch - 12 A…

A: The solution can be achieved as follows.

Q: Key = 93 ohm • Consider a single phase three wire power supply as shown in the figure below. This is…

A: In the circuit, 2 independent voltage sources are supplied to the three resistive load. Find the…

Q: A source of AC emf E₁ = 100/0º volts with an impedance of Z₁ = 20/0° ohms is connected in parallel…

A: In this question we will find current through load impedance for two parallel connected source....

Q: 1.1 We have two loads in delta and another in star in parallel, the impedances of the branches of…

A: Since you have posted the question with multiple subparts. we will solve the first two subparts for…

Q: Given the circuit shown, answer the following questions I 20 80 13 Vs - 24/60° v E V1 j6n V2 -j4 0…

Q: 6. Find the load impedance Z for the network shown for maximum power to the load. a. 1.26417° N b.…

A: This question belongs to circuit theory . It is based on the concept of maximum power transfer to…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

An abc-sequence, three-phase, 4-wire, 380-V supply is connected to an unbalanced
load having phase impedances of: Za = 8 + j6 Q, Z = 8-j6 Q and Zc = 5 Q. Impedance
of the neutral wire is 0.5 + j1 2. Line impedance is 1 + j2 0 per phase. Find the value of
the neutral current in polar form.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

2. A single-phase are distributor AB is fed from end A and has a total impedance of (0.3-0.3) ohm. At the far end, the voltage V-240V and the current is 100A at a p.f. of 0, 8 lagging. At the mid-point M. a current of 100 A is tapped at a p... of 0.6 lagging with reference to the voltage V_{M} at the midi-point. Calculate the supply voltage V Lambda j sending current I_{N} and the phase angle between V_{A} and V_{E}
18. A 415 V, 50 Hz, 3-phase supply of phase sequence RYB is connected to a delta connected load in which branch RY consists of R, = 100. branch YB conists of R₂ = 20 2 in series with X₂ = 60 Q and branch BR consists of a capacitor C= 30 uF. Take Vy as the reference and calculate the line currents. Draw the complete phasor diagrams. (Elect. Machines, A.M.I.E. Sec. B. 1989) 14.54, 1, 10.66 2172,92, 14.46 2-471 (1 = 7.78
Part g
Q2
Line Voltages at the terminal Pz:- The of abaancat Y conmected load is----- Each Phase of the load cousist of loL30 S2 Find the active s Reactive and somflex Power fer Phase then Find the total load. Var=12010, Powers for Heree phase
i need the answer quickly
27. Cartridge fuses and fuse holders shall be classified according to their NEC 240.61. ranges per a. Voltage only b. Ampere only c. Voltage or Ampere d. Voltage and Ampere
Determine the value of the impedance, Z₁, that causes maximum power transfer in the circuit shown in Figure Qlc. 52 j24n -j12.35n (V₂) j2403 j24n Figure Qle B
A balanced load is connected in star across a 3 phasec415V 50Hz supply. The load consists of a coil of resistance 25 ohms and inducrance 0.5 henry in paeallel with a purw resistance of 28 ohms and a pure capaciror of 60microfarads capacitance ,in each branch. Calculate a. The line currents? Need full working and answer has to be 9.3A Formola for inductance XL= 2×3.142FL FORMOLA FOR CAPACITOR XC= 1/2×3.142×FC
A three-phase feeder supplies two loads A and B at 380 V (Figure 2).Find the impedance of load A of (55 + j89) ohms and that of load B of(90 + j66) ohms. Ordered as currents in phases A that feed the twoloads, and as currents in the delta connected load.
Q-3-) a V346.41 V b Z=0+339 Z=0+j3Q Z=0+/39 m Line V₂ R R R=1252 Star-Connected load R b-) Find the voltage drop value in the energy distribution line. c-) Find the voltage V₂ at the load ends at the end of the line. R B R R=1892 Delta-Connected load In the figure above, two balanced 3-phase delta and star-connected loads are connected in parallel to a balanced three-phase power distribution line. Delta and star connected loads are completely resistive and the resistance values per phase are 18 2 and 12 22, respectively. The phase-to-phase voltage value of the source feeding the line is 346.41 V (rms), and it is assumed that the three-phase network between the source and the load has an inductive reactance value of 3j 2 per phase. a-) Find the total current drawn from the source, active and reactive power values by selecting the Van voltage as a reference value.
Please find Preal, Ptotal, and Pvar