Absorbances of a series of phosphate standard solutions measured using UV-Vis spectrophotometer using 1.0 cm pathlength glass cuvette at 415 nm aregiven in table 2 below.7.Table 2Standard solutionConcentration (mmol/L)AbsorbanceStd 10.00.1Std 20.15Std 30.20.28Std 40.30.4Std 50.40.55Std 60.50.7If an unknown sample exhibits an absorbance of 0.45. Determine thephosphate concentration in this unknown sample solution, using:a)Calibration plotb)Least-square method

A question based on concentration, which is to be accomplished.

Absorbances of a series of phosphate standard solutions measured using UV- Vis spectrophotometer using 1.0 cm pathlength glass cuvette at 415 nm are given in table 2 below. Table 2 Standard solution Concentration (mmol/L) Absorbance Std 1 Std 2 0.0 0.1 0.15 Std 3 Std 4 0.2 0.3 0.28 0.4 Std 5 0.4 0.55 0.7 Std 6 0.5 If an unknown sample exhibits an absorbance of 0.45. Determine the phosphate concentration in this unknown sample solution, using: a) Calibration plot b) Least-square method

Absorbances of a series of phosphate standard solutions measured using UV- Vis spectrophotometer using 1.0 cm pathlength glass cuvette at 415 nm are given in table 2 below. Table 2 Standard solution Concentration (mmol/L) Absorbance Std 1 Std 2 0.0 0.1 0.15 Std 3 Std 4 0.2 0.3 0.28 0.4 Std 5 0.4 0.55 0.7 Std 6 0.5 If an unknown sample exhibits an absorbance of 0.45. Determine the phosphate concentration in this unknown sample solution, using: a) Calibration plot b) Least-square method

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Kindly answer this question i, ii & iii
Report table 2: Determination of Molar absorptivity of K2CrO4 ppm of K2CrO4 in "DILUTE STOCK (5mL/50mL)"=1.5012 Molarity of K:CrO4 in "DILUTE STOCK(5mL/50mL)" = 7.7319× 10^-3 Peak wavelength λmax=372 nm From single wavelength values Peak Absorbance From spectrum A = 0.487 8=> 1 2 3 4 A= 0.370 A=0.434 A= 0.487 A= 0.347 8= 8= 8= 1.2864×10^6 1.5171×10^6 1.7023×10 6 1.20642×10^6 Average & (for the 4 readings) Standard deviation of a 95% Confidence interval of a = 1.428055×10^6 Show sample calculation (for solution 1): = A/b.c = Molar Absorption= 0,370/(3.72*10^-5)(7.7319× 10^-3)= 1.2864×10^6 M^-1cm^-1
SPECTROPHOTOMETRY Two groups in a BIO 120 lab extracted a blue-violet pigment from mayana plant which was to be used as a natural dye for Philippine textiles. To determine the concentration of the pigment isolated, each group made a standard curve using commercially available indigo dye in dimethylsulfoxide (DMSO). The following data were obtained by the two groups: Table 4. Absorbance readings of standard solutions of varying concentrations of indigo dye in DMSO. Pure DMSO 0.115 Standard solutions (ppm) Group 1 Data Group 2 Data 0.2 0.398 0.224 0.4 0.563 0.437 0.6 0.732 0.603 0.8 0.833 0.811 1.0 1.008 0.966 1. Show the constructed standard curves of the two groups with proper figure titles. 2. Which of the two groups generated a better standard curve? Justify your answer by providing the R? value for each data set. 3. The extracted pigment has an absorbance of 0.983. When a 0.2 mL-aliquot of the extract was diluted to 1.0 mL, the absorbance of the diluted solution was found to be…
What is the molar extinction coefficient at 625 nm for this copper (II) acetate solution? How was it determined? Standard Solution Concentration (M) Absorbance 1 0.025 0.049 2 0.050 0.153 3 0.100 0.242 4 0.200 0.499 5 0.250 0.694
Following AAS analysis, a graph of absorbance versus ppm nickel standard gave a best-fit line y = 0.0428x + 0.0487 . Calculate the ppm nickel in the well water sample having an absorbance of 0.675. 0.13 15.91 0.08 14.60
In the determination of lead content in a solid food sample, 1 g of the solid food sample was extracted with 10 mL of solvent and then diluted to a final volume of 50 mL. A calibration plot of lead standards was obtained from the standard solutions of 1 to 50 ug/mL and it gave a linear regression line of y = 0.025x + 0.004. The wavelength for lead analysis is 283.3 nm. The absorbance value for the extract was 0.302 arbitrary units. Calculate the percentage of Pb in 1 g of the solid food sample.
The absorbance for a dye sample of unknown concentration is measured and the corrected absorbance is 0.666. The standard curve created is found to have this linear equation: y = 0.153x + 0.043 Calculate the concentration (ug / mL) of the dye sample. 4.54 3.33 4.07 5.17 2.07
Abs at wavelength 1 (A = Abs at wavelength 2 (^ =, Sample nm) nm) Cr* Ni2+ Unknown Set up the equation for the two wavelengths using Beer's Law and calculate the concentrations of the metal ions in your unknown using two simultaneous equations: at wavelength 1: A1 = Ailccr + AılCNi at wavelength 2: A2 = A2lCcr + A2lCNi
Please don't copy paste another platform.
What is the molar absorptivity of a 2.50 x 10-4 M solution if its absorbance at 550 nm is 0.500? The sample is placed in the standard 1-cm quartz cuvette. 2.00 x 10-3 M-1cm-1 5.00 x 10-4 M-1cm-1 2.00 x 103 M-1cm-1 1.25 x 10-4 M-1cm-1
Given the calibration curve below, what is the limit of linearity? Absorbance 2000 1800 1600 1400 1200 1000 800 600 400 200 0 Ο 0.2 μg/ml Ο 0.4 μg/ml Ο 0.8 μg/ul Ο 1.2 μg/ul 0 Non-linear regresssion ...... 1 Concentration µg/μl 0.2 0.4 0.6 0.8 R²=0.9966 1.2 1.4 1.6
Maria was tasked to determine the concentration of a Fe2(SO4)3 solution. She prepared 5 different standards of Fe2(SO4)3 using the table below as her guide. She ran the standards and the unknown solution through UV-VIS spectroscopy and recorded the absorbances of each solution. HINT: use the dilution equation to determine the concentration of Fe2(SO4)3 in each test tube before preparing the standard curve. NOTE: No need to force the line to pass through zero. Just graph the data as is. What is the slope of the line of the standard curve from the given data? What is the concentration of the unknown solution?