A Y-connected balanced 3 phase source with z=0.2+j0.1/phase is connected to a Y-connected balanced load with z= 30 + j29 / phase. The line joining the source and the load has z = 0.9 + j0. 1/ phase. Assuming a + sequence for the source voltages and that Van = 110 L 20. V , find the line voltage and current.

A Y-connected balanced 3 phase source with z=0.2+j0.1/phase is connected to a Y-connected balanced load with z= 30 + j29 / phase. The line joining the source and the load has z = 0.9 + j0. 1/ phase. Assuming a + sequence for the source voltages and that Van = 110 L 20. V , find the line voltage and current.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A delta connected load (Figure 2) has an impedance Z is(12 + j35) ohms. If the applied VAB voltage is 380 V with -50º phase . Get the current IC and load IAB current.
Given at the load: Vioond = 452-25° VRMS, 452-25° VRMS, Iload What are the real and reactive power and power factor at the load? Exclude the units. real power: reactive power: power factor: Iload-10-25 ARMS what type of impedance is seen at the load? R. L. or Ch
i need the answer quickly
Determine the value of the impedance, Z₁, that causes maximum power transfer in the circuit shown in Figure Qlc. 52 j24n -j12.35n (V₂) j2403 j24n Figure Qle B
Derive an equation for the total instantaneous power absorbed by a balanced three-phase load. Be sure to clearly list any assumptions you make in your derivation.
solve it
A three-phase A-connected generator has an inter- nal impedance of 9 + j90 m2/þ. When the load is removed from the generator, the magnitude of the terminal voltage is 13,800 V. The generator feeds a A-connected load through a transmission line with an impedance of 20 + j180 m2/þ. The per-phase impedance of the load is 7.056 + j3.417 N. a) Construct a single-phase equivalent circuit. b) Calculate the magnitude of the line current. c) Calculate the magnitude of the line voltage at the terminals of the load. d) Calculate the magnitude of the line voltage at the terminals of the source.
A balanced three-phase load requires 1.8kW and power factor 0.5. If the line voltage at the terminals of the load is 230 V. the magnitude of line current is: Select one: a. 7.82 A O b. 9.03A O c. 15.65 A O d. 4.51 A
Solve it please fast
Please Answer My Questions in 30 minutes i'm very needed... Please thank u...
i need the answer quickly
20) Two AC generators A and B are in Parallel. Each generator has an emf of 1000V per phase and in phase, the phase impedance are ZA = 0.1+j2 ohms, ZB = 0.2+j3.2 ohms respectively. If the common load has an impedance of (2+j1) ohms per phase, solve the voltage per phase at the load