A uniform symmetrical beam is supported at two pin joints as shown below. It has a length L and a uniformly distributed load pz (x) = pis applied. The maximum bending moment My (x) will be half way along the beam. L р If the length L is 6.2 m, and the distributed load p is 2,400 N/m, then calculate the value of My (x) at the mid-point. Enter your answer as an integer, in Nm but without the units.

Q: Activity IPA Activity IPA D B D, E C, F, G C, G C A, B H, I FGHH

A:

Q: What kind of documentation should be done by the field personnel?

A: Few accurate notes were maintained, and all of the contractor 's correspondence was informal in…

Q: According to the information given in the table, draw the project (in a circle) and indicate it with…

A: Dotted line represents Dummy network.

Q: What are Schedule rep[orts?

A: In , civil engineering the projects work on the concept of achieving milestone . It comprises of…

Q: Why is the Resident Project Representative responsible for the record-keeping system?

A: Resident Project Representative is a person working on a project, typically on a full-time basis, to…

Q: What are the factors of change order preparation?

A: Change orders are among the most common forms of construction delays, budget overruns, driving scope…

Q: Draw the original network and calculate the CPM values, then check the effect of these updates and…

A:

Q: A constraint is a limitation to the space needed to perform an activity. O physical technical…

A: Activity is characterized as the measure of work played out that converts contribution to proper…

Q: Question 24 Resource is a situation in which more resources than available are assigned to an…

A: Answer Resource Allocation Resource allocation is the way or process used to assigning and…

Q: What is the program evaluation review technique?

A: The program evaluation review technique (PERT) is a visual tool, which is used in project planning.…

Q: For the following network all times are in days. Activity Duration Predecessor 5 10 A B 15 10 A A D…

A:

Q: How is the CPM scheduling program helpful to the Engineers?

A: The Critical Path Method (CPM) scheduling program is an activity-oriented network program used for…

Q: Please round to the nearest Hundredth (i.e., 0.01). No Comma! A square pile, 21 m long is driven…

A: Pile Foundation : The structure is supported by foundations, which also transfer loads from the…

Q: What is a Notice to Proceed?

A: The objective of the question is to understand the concept of a 'Notice to Proceed' in the context…

Q: Who is responsible for preparing the weekly reports for the project?

A: The Project Manager is responsible for preparing and maintaining the weekly reports for the project.…

Q: Incident is an unexpected or unplanned event that may result in physical harm, death, losses and…

A: If unexpected or unpredicted things or events takes place then we call it as Incident. Yes, Such…

Q: What is S-curve scheduling?

A: To define the S-curve scheduling we need to understand the S-curve. An S-curve could be a…

Q: What preparations can be made for close out project?

A: Project closure activities make sure the recording project documents, archiving in structure method…

Q: What is a job progress scheduling?

A: The construction management has the responsibility of supervising the planning, scheduling,…

Q: Write the five basic project planning steps when setting up a CPM Schedule?

A: Critical path is defined as the path when the duration of activities along this paths adds up to…

Q: linear schedule

A: Linear Scheduling, also known as ,the Linear Scheduling Method, is the development of project…