A tank contains (1000) liter of brine with (15) kg of dissolved salt. Pure water enters the tank as a rate of (10) liter/min. The solution is kept thoroughly mixed and drawn from the tank at the same rate; find the amount of salts at any time.

A tank contains (1000) liter of brine with (15) kg of dissolved salt. Pure water enters the tank as a rate of (10) liter/min. The solution is kept thoroughly mixed and drawn from the tank at the same rate; find the amount of salts at any time.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Gravity thickener analysis and design − a gravity thickener concentrates waste activated sludge…

A: Given Data: The waste activated sludge flow rate is 250,000 gal/day. The suspended solids…

Q: 9. A core sample is saturated with Oil, Gas and Water , the initial weight of the saturated sample…

A: Given data - bulk volume of sample = 100 cc Initial weight of saturated sample is 220 gm Increased…

Q: 1. A tank initially holds 10 gal of fresh water. At t 0, a brine solution containing 4 pounds of…

Q: b) From the following data calculate the carbonate bicarbonate and hydroxide alkalinities.…

A: Methyl orange alkalinity=total alkalinity p=phenolphthaleint=Methyl orange alkalinity

Q: Available chlorine in bleaching powder solution is 0.5mg/ml. To obtain a chlorine dose of 0.1 mg/1…

Q: Calculate the pH of a solution that has a pOH of 8.70.

A: Introduction : The given question is related with environmental engineering . In this question we…

Q: A sample of water was analyzed through titration with 0.01 N HCI. 150 ml of the water required 30.0…

A: Alkalinity is defined as the ability of water to neutralize acids. Alkalinity is caused by hydroxyl…

Q: Two rivers with different sodium (Na") levels converge and form a single river downstream of the…

A: River 1 : Na = 58.0 mg/L, Load = 7800 lb/day River 2: Na = 150.0 mg/L, Load = 5300 lb/day To…

Q: A 400-gallon capacity tank initially contains salt solutions consisting 150 gallon of water and 25…

Q: Water containing 50 mg/L of monodisperse (uniformly sized) spherical particles of diameter 100 μm…

Q: QI/ A tank is initially filled with ( 250 gal) in which 50 lb of salt are dissolved. salt Fresh…

Q: A water sample is tested to have an alkalinity of 300 mg/L as CaCO3. The Ca^2+ concentration is 120…

Q: In a sludge digestion tank, if the moisture content of sludge is reduced from 90% to 80% then th…

Q: 4 2.LacticacidhasaKa of1.38x10 . What is the pH of the solution that results when 25.0 mL of 0.300…

A: Since 25.0 mL of 0.300 M lactic acid are titrated with 20.0 mL of 0.375 M KOH solution. ⇒0.375 M KOH…

Q: The Volume of NaOH (0.01N) when use ph.ph indicator is 12.4mL and 3mL when use methyl Orange (M.O)…

A: Given data: Normality of NaOH = 0.01 N Volume of methyl orange (V1) = 3 mL Volume of phenolphthalein…

Q: Determine the pH of the solution produced in the reaction flask when 25.00mL of 0.100 M NaOH has…

A: to find - ph of solution

Q: Fresh sludge has moisture content of 99% and, after thickening, its moisture content is reduced to…

A: Given- For fresh sludge- moisture content- w1=99%, For thickened sludge- moisture content- w2=96%.…

Q: A well stirred tank with a capacity of 500 gal originally contains 200 gal of water with 100lbs of…

Q: A river with 400 ppm of salt (a conservative substance) and a flow of 25.0 m3/s receives…

A: Given:- The concentration of salts in a river = (C1) = 400 ppm The flow rate of the river = (Q1) =…

Q: 6 Ydu will obtain 2.0 L of tap water for you water hardness test. The water hardness test uses a…

A: We will solve this question in step no. 2

Q: In wastewater treatment the digestion of sludge produces a useful gas (carbon dioxide and methane),…

A: Discharge is the main quantity in any sector that is used to transfer fluid from one place to…

Q: Fresh sludge has moisture content of 99% and, after thickening, its moisture content is reduced to…

A: Given that :- Fresh sludge has moisture content w1=99% After thickening moisture content = w2=96% To…

Q: *, Calculate the amount of lime and soda required to treat two million litre (M.L.) of hard water,…

Q: An industry is having a water treatment plant which produces sludge having moisture content of 97%.…

A: Given: A water treatment plant produces a sludge having moisture content of 97 % P1=97 % With the…

Q: Choose the process that will not disturb the following equilibrium. Co(g) + H2O(g) =CO2(g) + H2(g) O…

A: 1) Answer Option c Lechatelier's principle :- It states that, when a system at equilibrium is…

Q: 6. A tanks initially holds 100 gallons of salt solution in which 50 bs of salt has been dissolved. A…

A: Let Q = Amount of salt in the moisture 100 + (3-2)t = 100 + t = Volume of mixture at any time t…

Q: A tank initially contains 210 litres of fresh water. Brine containing 2.6 N/litre of dissolve salt…

A: The values given in the question are as follows: Initial fresh water in tank=210 lit Salt…

Q: A large rank contains 100 gal of brine in which 10 lb of salt is dissolved. Brine containing 0.2 lb…

A: Here as given, Brackish water containing 0.2 lbs entering tank at 6gal/min Salt entering tank rate=…

Q: The alkalinity of a water sample is 120 mg/1 as CaCO3. pH of the water sample is found to be 9.…

Q: If 100 mg of H,SO, (molecular weight 98 g/mole) is added to 1.021l of water, what is the final pH of…

A: Given data- 100 mg H2SO4Molar mass=98 g/mole1.02 l of waterTo Find-The final pH of solution

Q: quantity of water to be treated is 2 MGD. i Estimate the total hardness, carbonate hardness and…

A: Given:- quantity of water treated =12MGD Lime and soda process To find:- a)total hardness ,carbonate…

Q: 3.2 If an ion exchange water softener has 0.2 m' of ion-exchange resin with an exchange capacity of…

A: 3.2)

Q: Q1. Water has the following composition: calcium = 92 mg/L, magnesium = 31 mg/L, sodium = 16 mg/L,…

Q: 1- Explain the procedure to find the total solid and what's the unit for it? 2- In total dissolved…

A: Procedure to find the total solids and it's unit.

Q: 1. An oil of sp. gr. 0.9 is contained in a vessel. At a point the height of the oil is 50 m. Find…

Q: The raw sludge has solid content of 5% and the digested sludge has moisture content of 85%. The…

A: Given data, The raw sludge has solid content = 5% the digested sludge has moisture content = 85%.…

Q: Q- The sludge from the aeration tank of the activated sludge process (ASP) has solids content (by…

A: Given data: 1st case, Volume of sludge, Vsl1=V Percentage of solid mater, Ps1=2 2nd case, Volume of…

Concept explainers

Temperature related material properties

Temperature-related properties of materials are the properties that change or show any variation with temperature variations. Various properties of materials include physical properties, mechanical properties, chemical properties, electrical properties, magnetic properties, etc. The chemical, electrical, and magnetic properties of materials are important, but the physical and mechanical properties are more important. Based on their composition and chemical bonding, materials are classified as metals, ceramics, polymers, and composites.

Question

A tank contains (1000) liter of brine with (15) kg of dissolved salt. Pure
water enters the tank as a rate of (10) liter/min. The solution is kept
thoroughly mixed and drawn from the tank at the same rate; find the
amount of salts at any time.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

An anaerobic digester is operated with a hydraulic retention time (HRT) of 25 d and a flow rate of 0.85 m³/d. The influent substrate concentration is 18 g/L and the digestion process is assumed to follow first order kinetics with a Ko value of 0.09 d'¹. Calculate: (a) the liquid volume of the anaerobic digester, V (m³) (b) the effluent substrate concentration, So (g/L)
Water treatment..
Water analysis was carried out for a groundwater sample. The sum of the anions is equal to the sum of the cations. Calculatea) Total hardnessb) Carbonate and Non-Carbonate Hardness Hardnessc) Alkalinity
Note: Read the question carefully and give me right solution according to the question. I want clear solution with clear steps. A water contains 38.50 mg/L as CaCO3 of carbon dioxide, 288.00 mg/L as CaCO3 of Ca2+ and 53.00 mg/L as CaCO3 of Mg2+. All of the hardness is carbonate hardness. Using the stoichiometry of the lime soda ash softening equations, what is the daily sludge production (in dry weight, kg/day) if the plant treats water at a rate of 56.00 MGD? Assume that the effluent water contains no carbon dioxide, 30.0 mg/L as CaCO3 of Ca2+ and 10.0 mg/L as CaCO3 of Mg2+. Be sure to calculate the mass of CaCO3 and Mg(OH)2 sludge produced each day.
A water sample has a pH of 7.25. Determine the concentration of hydroxyl ion in the water sample.
Complete solution Civil engineering
Pls show clear and complete solution ty
This is not an assignment. Please give me right solution according to the question
Mixtures of Non-Reacting Fluids Initially ,a container contains 100 L of water and 50 g of dissolved salt. Brine is pumped into the tank at a rate of 2 L/min with a salt content of 2 grams per liter. At a rate of 3 L/min, the well-stirred mixture is pushed out of the tank. Determine the solution's concentration after 1 hour.
I need a quick solution within 5 minutes With my best wishesTon.
(a) (ii) Following chemical species were reported for water sample from a well. Concentration (milli equivalent)/L 15 15 05 30 12 18 8.8 Species Chloride (CL) Sulphate (SO2-) Carbonate (CO2) Bicarbonte (HCO3) Calcium (Ca²+) Magnesium (Mg2+) pH Find (i) The total hardness (in mg/L) as CaCO3 (ii) Alkalinity present in the water (in mg/L) as CaCO3.
9-2 (15 pts) Determine the alkalinity, total hardness, carbonate hardness, and non-carbonate hardness (in mg/L CaCO3) for the water (pH 7.4) with the following chemical concentrations. Calculate the doses of lime and soda ash to soften this water. Constituent Concentration, mg/L Ca2+ 95 Mg2+ 13.5 Na 25.8 HCO3 244 SO 2- 73 CI 67.8 H2CO3 7.7