A sample of water was analyzed through titration with 0.01N HCI. 150 mL of the water required30.0 ml of 0.01 N HCI to titrate it to the phenolphthalein endpoint and 14.0 mL of the same HCIsolution to titrate it further to the methyl orange endpoint. Assuming the sample contains nocalcite particles, what are the total and carbonate alkalinities of the sample in meq/liter and thetotal alkalinity in mg/liter as CaCo,? Also, what are the concentrations of the major alkalinityspecies?

Alkalinity is defined as the ability of water to neutralize acids. Alkalinity is caused by hydroxyl…

A sample of water was analyzed through titration with 0.01 N HCI. 150 ml of the water required 30.0 ml of 0.01 N HCI to titrate it to the phenolphthalein endpoint and 14.0 ml of the same HCI solution to titrate it further to the methyi orange endpoint. Assuming the sample contains no calcite particles, what are the total and carbonate alkalinities of the sample in meg/liter and the total alkalinity in mg/liter as CaC0,? Also, what are the concentrations of the major alkalinity species?

A sample of water was analyzed through titration with 0.01 N HCI. 150 ml of the water required 30.0 ml of 0.01 N HCI to titrate it to the phenolphthalein endpoint and 14.0 ml of the same HCI solution to titrate it further to the methyi orange endpoint. Assuming the sample contains no calcite particles, what are the total and carbonate alkalinities of the sample in meg/liter and the total alkalinity in mg/liter as CaC0,? Also, what are the concentrations of the major alkalinity species?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A given sludge with 98% moisture content is X times more bulky than with 95% moisture content. The value of X is ______
The raw sludge has solid content of 5% and the digested sludge has moisture content of 85%. The ratio of volume of raw sludge to the volume of digested sludge is .
(c) An analysis of a water sample has produced the following concentrations, as shown in Table 1(c). Determine the following and comment on the result: (i) Total Hardness in mg/L as CaCO3 (ii) Carbonate Hardness in mg/L as CACO3 (iii) Alkalinity in mg/L as CACO3
Calculate the porosity
Muni.waste.
lon concentrations obtained for a ground water sample (having pH = 8.1) are given below Ca2+ Mg2+ Na+ HCO3- SO4²- CI- 2- Ion Ion concentration 100 6 (mg/L) Atomic weight Ca 40 Mg = 24 15 Na || 23 250 H= 1, C 16 12, 45 S = 32, O =16 39 CI= 35.5 Carbonate hardness (mg/L as CaCO3) present in the above water sample is
Pls ans soon
9-2 (15 pts) Determine the alkalinity, total hardness, carbonate hardness, and non-carbonate hardness (in mg/L CaCO3) for the water (pH 7.4) with the following chemical concentrations. Calculate the doses of lime and soda ash to soften this water. Constituent Concentration, mg/L Ca2+ 95 Mg2+ 13.5 Na 25.8 HCO3 244 SO 2- 73 CI 67.8 H2CO3 7.7
In a water sample, the concentrations of 2+ Ca²+, Mg²+ and HсO₂ are 100 mg/L, 36 mg/L and 122 mg/L, respectively. The atomic masses of various elements are: Ca = 40, Mg = 24, H = 1, C = 12,0 = 16 The total hardness and the temporary hardness in the water sample (in mg/L as CaCO3) will be A 400 and 100, respectively. B 400 and 300, respectively. c) 500 and 100, respectively. D 800 and 200, respectively.