a-) Suppose two hosts are connected with each other by means of a 100-Mbps link, and assume the round-trip time between them is 1 msec. What is the minimum TCP window size that would let TCP achieve the maximum possible throughput between these two hosts? (Note: Assume no overhead.) (b) A host is receiving data from a remote peer by means of TCP segments with a payload of 1460 bytes. If TCP acknowledges every other segment, what is the minimum uplink bandwidth needed to achieve a data throughput of 1 Mbytes per second, assuming there is no overhead below the network layer? (Note: Assume no options are used by TCP and IP.)

Q: In this problem, we consider sending real-time voice from Host A to Host B over a packet-switched…

A: We need to find the elapsed time when the first bit is formed.

Q: The Data field in both figures signifies the data from the application layer while the other fields…

A: Given that, Maximum transmissible unit or data packet size in transport layer= 1000 bytes Total…

Q: 1.4-6 Maximum end-end throughput (e). Consider the scenario below where 4 TCP senders are connected…

A: Given data : R = 1Gbps Rc = 300 Mbps  Rs = 200 Mbps

Q: Assignment 5: Both TCP and UDP are widely used IP transfer layer protocols. For applications…

A: Introductions :We have to list out some points why Some TCP/IP Applications Use UDP?

Q: Assume that TCP implements an extension that allows window sizes much larger than 64 KB. Suppose…

A: We begin with a 1 KB window size that doubles with each RTT. Realizing that 1 MB is 1024 times…

Q: The figure shows a TCP transaction. Assume Host A always has data to send, and each packet has size…

A: A)   Here since 2nd packet is lost,   ACK#1 = ACK#2 = ACK#3 =100 (sequence number of 2nd packet)…

Q: Suppose an extension of TCP allows window size much larger than 64 KB. Assume the extended TCP runs…

A: Solution :

Q: sender sends 8 TCP segments at t = 1, 2, 3, 4, 5, 6, 7, 8. Suppose the initial value of the sequence…

A: TCP Sequence Number is a 4-byte field in the TCP header that shows the primary byte of the active…

Q: Assume two hosts, A and B, that are linked by a single link with a rate of R bps and are spaced m…

A: Sure, let's break down the questions step by step and calculate the values.Rate of the link (R) = R…

Q: Host A and B are linked directly to a 100 Mbps link. There is a TCP link between the two servers,…

A: Host A and B are linked directly to a 100 Mbps link. There is a TCP link between the two servers,…

Q: Maximum end-end throughput (e). Consider the scenario below where 4 TCP senders are connected to 4…

A: According to the company's policy, we are obliged to answer only the first question in case of…

Q: Suppose an HTML file references two very small objects on the same server (total 3 object including…

A: Introduction The Hypertext Transfer Protocol (HTTP) is indeed an application layer protocol that…

Q: 01 Consider two nodes, A and B. Suppose the network path from A to B has bandwidth of 5 KB/s (5,000…

A: Through put of stop and wait protocol is = Tt (data packet) / Tp (data packet) +Tt(ack packet) +…

Q: Performance: Throughput. Consider now the (new!) network shown below, with a new sender (E) sending…

A: To determine the maximum end-to-end throughput for the new E-to-D session in the given network, we…

Q: Host A and B are communicating over a TCP connection, and Host B has already received all bytes up…

A: Given data: Host A and B are communicating over a TCP connection, and Host B has already received…

Q: Suppose you are using TCP over a 10-Mbps (10 × 2^ 20 bps) link with a latency 100 ms (RTT 200 ms) to…

A: (a) How many RTTs does it take until slow start opens the send window to 10MB? Solution: =>…

Q: Question 4: Consider the figure below in which a TCP sender and receiver communicate over a…

A: It is a connection-oriented protocol which guarantees in-order delivery of segments by means of…

Q: sender sends 8 TCP segments at t = 1, 2, 3, 4, 5, 6, 7, 8. Suppose the initial value of the sequence…

A: TCP Sequence Number is a 4-byte field in the TCP header that shows the primary byte of the active…

Q: (a) The transmission time of a bit or group of bits is sometimes referred to as their "width" on the…

A: Dear student, As per our guidelines, you have uploaded multiple questions. Experts are only allowed…

Q: Consider sending real-time data from Host A to Host B over a packet-switched network. Host A takes…

A: Given: Real-time data is being sent from Host A to Host B over a packet-switched network. Host A…

Q: sender sends 8 TCP segments at t = 1, 2, 3, 4, 5, 6, 7, 8. Suppose the initial value of the sequence…

A: This is very simple. At t=1, data segment 1 is sent to the receiver. The delay is 5 units. They…

Q: The maximum packet size (Maximum Transmission Unit or MTU) of an IP packet including IPv4 header on…

A: Here is the explanation regarding the maximum packet size.

Q: Hosts A and B are directly connected with a 1 Gbps link. There is one TCP connection between the two…

A: Given, Hosts A and B are directly connected with a 1 Gbps link. There is one TCP connection between…

Q: Through a TCP link Host A transmitting a big file to host B. There is never any packet loss over…

A: The following is the Solution

Q: You need to send a 2100-byte chunk of data using TCP from Computer A to Computer B. TCP segments are…

A: The Answer is

Q: Consider a TCP connection with the following parameters:  a) Initial ssthreshold = 4 segments b)…

A: Q1 Answer:- We have the given data: Initial ssthreshold = 4 segments Round Trip Time (RTT) = 10…

Q: Suppose two hosts are connected with each other by means of a 100-Mbps link, and assume the…

A: Given's: Two hosts are connecters with a 100-Mbps links. RTT(round-trip time) = 1 m sec A…

Q: The figure below shows a network of four clients: A, B, C, and D, connected through a router, X. The…

A: To calculate the total delay for each packet, it needs to consider both the transmission delay and…

Q: bps, where S=10-R. Further suppose that the TCP receive buffer is large enough to hold the entire…

A: The answer is..

Q: Q.4) Consider the scenario below where 4 TCP senders are connected to 4 receivers. Senders transmit…

A: Here is the explanation of the above problem.

Q: - Suppose a TCP message that contains 1024 bytes of data and 20 bytes of TCP header is passed to IP…

A:

Q: A TCP PDU of length 40,513 octets (including the TCP header) is to be transmitted over a physical…

A: To calculate the number of bits sent over the connection from the source to the destination, we need…

Q: TCP a. Consider two TCP connections, one between Hosts A (sender) and B (receiver), and another…

A: Question Consider two TCP connections, one between Hosts A (sender) and B (receiver), and…

Q: Propagation Nodal Queuing Transmission processing (waiting for transmission) Assume the two hosts on…

A: (A). Packet Length (L) = 1200 bytes = 8 x 1200 bits Transmission rate (B) = 3 Mbps = 3 x 106…

Q: TCP congestion control example. Consider the figure below, where a TCP sender sends 8 TCP segments…

A: Given, a figure where 8 TCP segments are sent by TCP sender at time t =1, 2, 3, 4, 5, 6, 7, 8.…

Q: Consider a TCP connection with the following parameters:  a) Initial ssthreshold = 4 segments b)…

A: Q1 Answer:- We have the given data: Initial ssthreshold = 4 segments Round Trip Time (RTT) = 10…

Q: Consider a TCP connection between Host A and Host B. Suppose that the TCP segments traveling from…

A: When TCP segments are traveling from the A to B the source will be x and port will be y. Here they…

Network transmission cabling

A network is a collection of devices connected by communication links. A device can be a computer or any instrument capable of sending and receiving data or information formed by other nodes toward the network. A channel that connects people or things is known as a network. It sends the data from one place to another. It is the basic concept of a computer, network, and data communications.