Answered: A student was in a rush and skipped…

A student was in a rush and skipped elution with ethanol and went straight for water. How would the student’s separation be affected?

Introduction to General, Organic and Biochemistry

11th Edition

ISBN:9781285869759

Author:Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar Torres

Publisher:Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar Torres

Chapter1: Matter, Energy, And Measurement

Section: Chapter Questions

Problem 1.64P

See similar textbooks

Similar questions

1. Several students performed this experiment without paying adequate attention to the details of the procedure. Briefly explain what effect each of the following procedural hanges would have on the size of the volume- to- temperature ratio calculated by the students. (a) One student failed to replenish the boiling water in the boiling- water bath as the flask was being heated. At the end of the 6 min of heating, the boiling water in the bath was only in contact with the lower portion of the flask. (b) Following the proper heating of the flask in the boiling water, a student removed the flask from the boiling- water bath but only partially immersed the flask in the ice-water bath during the cooling period. (c) A student neglected to close the pinch clamp before removing the flask from the boiling water bath and immersing it in the ice-water bath. (d) One student neglected to measure the volume of the flask before leaving the laboratory. Because the procedure called for a 125-mL…
The solubility of BaSO, in water at 25 °C is measured to be 0.0023 Use this information to calculate Ke, for BaS04. L sp Round your answer to 2 significant digits. |x10
2. Two students weigh a gelatin capsule (0.112g). Next they add pieces of aluminum-zinc alloy to the capsule and weigh the capsule and alloy (0.271g). They weigh out an empty beaker (141.209) and begin the experiment. After the reaction, they determine the mass of the beaker (with displaced water) to be 307.712g. The temperature of the water was 21 degrees Celsius and the barometric pressure was 745.9 mmHg. Fill the calculation section of the table on the following page.
Dashboard My Home OWLV2 | Online teaching and learning resource from Cengag [References) A student gently drops an object weighing 15.7 g into an open vessel that is full of ethanol, so that a volume of ethanol spills out equal to the volume of the object. The experimenter now finds that the vessel and its contents weigh 10.6 g more than the vessel full of ethanol only. The density of ethanol is 0.789 g/cm°. What is the density of the object? Density = g/cm³ Submit Answer Try Another Version 10 item attempts remaining
You plot A vs Conc (mg/mL) for a set of 5 standards in mg/mL and get the equation for the line as 0.962=0.310x+0.315. Solve for x and report the results with correct units and sig-figs. Is this question really just as simple as solving for x? I feel like I'm missing something here...
Archimedes, a famous Greek scientist, was given a problem by King Hieron II of Syracuse (Sicily). The king suspected that his crown, which was supposed to be made of pure gold, contained some silver alloy, and he asked Archimedes to prove or disprove his suspicion. (It turned out that the crown did not contain silver.) How would you experimentally determined whether or not the crown was pure gold? (Hint: The method came to Archimedes when getting into a full bathtub. See the footnote in Experiment 22 for Archimedes’ solution.)
1. How would the accuracy of your determined Keq change if all of your volume measurements were made with graduated cylinders rather than pipets?
PART 3 A Volumetric Flask + A С — ALI50 SOA A 50-mL volumetric flask measures a volume of 50.00 mL. In this experiment, we want to show that this is true. 50.00 mL is the actual volume measured by this volumetric flask. EXPERIMENT: The mass of an empty volumetric flask is measured. Then water is added to the volumetric flask and the meniscus is adjusted to be at the correct level. Then the mass of the volumetric flask and the water is measured. Finally, the temperature of the water in the volumetric flask is measured. RESULTS: Mass of empty volumetric flask = 37.04 g Mass of volumetric flask and water = 86.83 g Temperature of the water in the volumetric flask = 23°C 4 Densities of water at different temperatures: Density of Water at Different Temperatures (g/cm) Temp, °C Density Temp, °C Density Temp, °C Density 18 0.99862 21 0.99802 24 0.99733 19 0.99844 22 0.99780 25 0.99708 20 0.99823 23 0.99757 26 0.99681 (a) Using the mass of the water measured and the density of the water,…
CH₂-COOH Citric acid has the formula HO-C-COOH I CH₂-COOH CH2–CDD - Na* + HD-C-CDD- Na CH₂-COO- COO-Na A 25.0 mL sample of a concentrated citrus fruit cordial component (e.g. for lime juice), used in the food & drinks industry, was diluted to 250 mL in a graduated volumetric flask. A 25.0 mL sample of this diluted solution, required, on average, 22.5 mL of a standard 0.100 molar sodium hydroxide solution using phenolphthalein indicator for the titration end-point. A) 0.0075 Assuming all the acid in the cordial was citric acid, calculate the concentration of the acid in g/mL in the original solution. B) 0.576 D and is tribasic acid, forming the tri-sodium salt on complete neutralisation with sodium hydroxide. 1.44 0.00225
A chemist analyzes a sample of iron ore furnished by the National Institute of Standards and Technology, NIST. He obtains the following results: = 10.52%, s = 0.05, n = 10. The NIST's value for this sample is 10.60% Fe. Is the chemist's result (mean) significantly different at the 95% confidence level?
In an experiment, a student was asked to measure the densities of liquid acetone and metallic chromium. He was given a pycnometer which weighed 26.880 g empty. When filled with water and stoppered, the mass was recorded as 54.992g at 28C. The pycnometer was cleaned and filled with acetone. The mass was 49.137 g. Again, the flask was cleaned and dried. Into it were added some chunks of chromium and the total was found to weight 78.666 g. Leaving the chromium in the pycnometer, it was then filled with acetone. The flask, metal and acetone were found to weigh 95.199 g. From this data, calculate the density of acetone and the density of chromium (show all your calculations).
After creating her standard curve for absorption versus the concentration (M) of FD&C Red 40 and processing her data, Sally found that her drinking strength Kool-Aid sample had a concentration of 4.692 x 10–5 M. If 0.132 grams of Kool-Aid powder was used to prepare an 8-fl oz cup of her assigned flavor, what is the percent by mass of FD&C Red 40 in her Kool-aid powder? Report your answer as a percentage with two places after the decimal. Do not include the percentage sign in your answer. Pay attention to units. You are trying to find the mass percentage of red dye, so you need to know each variable in the equation in Appendix B. Note that the percent by mass equation should be multiplied by 100. There may be some useful conversion factors in the experimental procedure.