A pump is used to draw water from a lower height to an open reservoir through pipe with length 10km and diameter 150 mm. velocity of 2m/s at the discharge. The exit of a pipe is connected to a bottom of a large round tank. Determine the maximum height up to which a large round tank open to the atmosphere can be filled. The loss coefficient at the exit of the pipe to the tank is 1. Friction factor is 0.015. The kinematic viscosity of water is 10-6 m²/s. the pump provides gage pressure of 2 MPa and average

Q: please explain how to get the friction factor

A: The objective of the question is to calculate the friction factor, the power supplied to the pump,…

Q: The diameters D & d piped, Venturi- meter like horizontal water flow sistem seen in the drawing is…

A:

Q: 1. Water (p = 1000- kg H = 10-3 flows in a horizontal constant-area pipe; the pipe cross ms section…

A:

Q: Water (viscosity of 0.001 kg/m.s  and density of 1000 kg/m3 ) is to be pumped through 50 m of pipe…

A:

Q: In the figure shown below, a thick filter is being tested for losses. The flow rate in the pipe is…

A:

Q: The shaft is supported at its ends by two bearings AA and BB and is subjected to the forces applied…

A:

Q: Water is being pumped the through one inch diameter piping arrangement to a higher elevation (5…

A: Density Explanation:Step 1:Step 2:Step 3: Step 4:

Q: Water flows between two reservoirs A & B. The water level in A is 400 m AOD and in B is 385m AOD.…

A:

Q: water at 20°C is pumped through a smooth 12-cm-diameter pipe 10 km long, at a flow rate of 75 m3/h.…

A:

Q: A 230-m-long pipeline delivers 20°C water to a storage reservoir located downstream. The pipeline is…

A:

Q: Water flows from the nozzle attached to the spray tank shown in the figure below. Determine the…

A: Given:

Q: 3. A liquid with a density of 1500kg/m flows in a horizontal pipe 11.5m long. The entrance pipe with…

A:

Q: 1 J A pump is used to circulate a water from lower Tank to upper tank. The height difference between…

A: Given data: The height difference between the free surface is h=5 m The total head losses in the…

Q: here are two fully open gate valves (KV= 2 m) and three 90° elbows (K90°= 2.2 m) on the horizontal 4…

A:

Q: onsider the hydropower schematic shown below with a lake of 70m elevation above a turbine house.…

A:

Q: A 1.0 m radius cylindrical industrial tank filled with viscous oil to a level at a height h from its…

A: Given: Radius of tube = 0.2 m Radius of tank = 1.0 m speed of oil in tube = 0.35 m/s

Q: A centrifugal pump was purchased to pump the water from an open tank to a water jet spray cleaner.…

A: Given Datagauge pressure=75kN/m2d=0.64mh=15m

Q: (3) In the figure below, the pipe entrance is sharp-edged. Consider the flow rate Q to be 0.004…

A:

Hydronics