A permeability test was run on a soil sample with 8cm in radius and 10cm long. The level of water at point A and B from the datum is 18cm and 10cm, respectively. Determine the flow of water in cubic centimeter per hour that passes through the soil sample if the coefficient of permeability is 0.1388cm/sec. Point A Point 8 Sol Sample

A permeability test was run on a soil sample with 8cm in radius and 10cm long. The level of water at point A and B from the datum is 18cm and 10cm, respectively. Determine the flow of water in cubic centimeter per hour that passes through the soil sample if the coefficient of permeability is 0.1388cm/sec. Point A Point 8 Sol Sample

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The hydraulic conductivity of a soil sample (3.4 x 10-4 cm/s) has been determined via a permeability test. The water temperature was 28°C at the time of experiment. What is the hydraulic conductivity of the sample at the standard temperature of 20°C?
3. A falling head permeability test is performed on a fine gravel soil. The soil sample has a length of 120mm and cross-sectional area of 600mm?.The water in the standpipe flowing into the soil is 0.60m above the top of the sample at the start of the test. It falls 50mm in 30 min. The standpipe has a cross- sectional area of 200mm?. a. Make a sketch of the described condition. b. What is the coefficient of permeability in millimeters per second? c. What is the coefficient of permeability in feet per minute? d. On the basis of the calculated value for k, what is the probable soil type?
4. A constant-head permeability test was conducted on a soil sample retained inside a cylindrical mould with a length of 40cm and an inner diameter of 18cm. In the test setup, a total of 55cm³ of water was collected during 3 hours and 15 minutes after reaching a constant-head difference of 60cm. a. Calculate the hydraulic conductivity (cm/s) of the soil sample. b. Estimate the type and permeability class of the soil. (Show all working calculations.)
A constant-head test was conducted on a sample of soil 15cm long and 60 cm^2 in cross-sectional area. The quantiities of water collected was 50 cm^3 in 20 seconds undera a head difference of 24 cm. Calculate the hydraulic conductivity. If the porosity of sand is 55%, calculate the average velocity and the seepage velocity. Estimate the hydraulic conductivity of a similar soil with a porosity of 35% from the results test. Please show all work!!
The data from a falling-head test on a silty clay are: Cross sectional area of soil = 1000 mm^2 Length of soil sample = 200 mm Area of stand pipe = 40 mm^2 Head difference at time t = 0 is 500 mm Head difference at time t = 3 min is 300 mm a) Determine the hydraulic conductivity of the soil in cm/sec. b) What is the head difference at time t = 100 sec in mm
The figure shows the layers of soil in a tube that is 100mm x 100 mm in cross section. Water is supplied to maintain a constant head difference of 450 mm across the sample. The hydraulic conductivity of the soils in the direction of flow through them are given below. Compute the equivalent hydraulic conductivity in m/hr. Water supply h=450 mm Out flow Direction of flow Soil Soil Soil A B 200 200 200 mm mm mm K, = 2 x 10-4 cm/s KR = 3.7 x 10-2 cm/s Kc = 1.2 x 10 -5 cm/s Select one: a. 0.002124 b. 0.002412 c. 0.001224 d. 0.004221
From the constant head permeability test, the following values are given: Void ratio of specimen 0.46 Length of soil sample 450 mm Constant head difference 700 mm Water collected in a period of 180 seconds Cross-sectional area of soil sample 3.54 x 10-4 m³ 2.26 x 10-3 m² a.) Determine the coefficient of permeability in m/hour. b.) Compute the discharge velocity in mm/s. c.) Compute the seepage velocity in mm/s. d.) If the test was done at 24°C, what is its corrected coefficient of permeability?
The attached figure shows the soil sample prepared and setup for constant head permeability test. If the permeability of the soil is 4.5 x 10-3 cm/sec, what is the required time to collect 100 ml of outflow water under the steady state condition? 40 cm Soil in the pipe with internal diameter 20 cm Outflow collection 50 cm 40⁰ 90 cm -Datum- 10 cm
A cylindrical soil sample with length = 15cm and diameter = 4cm was taken from a site where a groundwater contamination piume was found. The sample was tested in the lab to determine its hydraulic conductivity. A hydraulic gradient of 0.05 was applied across the sample, and a flow rate of 0.025 cm³/sec was measured. Calculate the hydraulic conductivity of the soil sample using Darcy's law.
The figure shows a granular soil in a tank having a downward seepage. The water level in the tank is held constant by adjusting the supply from the top and the outflow at the bottom. The void ratio of the soil is 0.50 and the specific gravity is 2.7. H,0 0.8 m 1.1 m A 3.6 m 5.4 m B C Il a plezometer is placed at point B, to what height the water will rise above this point?