A lossless uncharged transmission line of length L = 0.45 cm has a characteristic impedance of 60 ohms. It is driven by an ideal voltage generator producing a pulse of amplitude 10V and width 2 nS. If the transmission line is connected to a load of 200 ohms, sketch the voltage at the load as a function of time for the interval 0 < t < 20 nS. You may assume that the propagation velocity of the transmission is c/2.

A lossless uncharged transmission line of length L = 0.45 cm has a characteristic impedance of 60 ohms. It is driven by an ideal voltage generator producing a pulse of amplitude 10V and width 2 nS. If the transmission line is connected to a load of 200 ohms, sketch the voltage at the load as a function of time for the interval 0 < t < 20 nS. You may assume that the propagation velocity of the transmission is c/2.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.35MCQ: The affect of the earth plane is to slightly increase the capacitance, and as the line height...

See similar textbooks

Similar questions

c) For a transmission line w/characteristic impedance Z0 = 50 W. At some point of the line, a forward wave has the voltage V+ = 10V and backward wave has the voltage V- = 4V. i) Currents of the forward wave and backward wave at that point. ii) Measured voltage and current at that point. d) A transmission line has the following properties: Length, L = 3 m. Characteristic impedance Z0 = 50 W. The load impedance ZL = 100 W. And phase constant b = p/3. Assume the forward voltage at z = 0 is VA =10ejp/4 At z = 3m, calculate: i) Forward voltage and forward current. ii) Backward voltage and backward current. iii) Measured (total) voltage and current across the load
Each phase of a transmission line is a bundle of 4 conductors that form a square with all sides equal to d=33 cm. Each conductor is stranded and has GMR = 0.5 cm. Find GMR of the bundle to be used in inductance calculations. Express your answer in cm with 2 digits after decimal point
The capacitance per unit length and the characteristic impedance of a lossless transmission line are C and Zo respectively. The velocity of a travelling wave on the transmission line is (a) Z.C (c) Zo C - UN (b) Z.C (d) Z
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
The distance between conductors of a single-phase line is 3 m. Each conductor is composed of five strands as shown above. Find the inductance of the line. D
A coaxial cable with a characteristic impedance of 50 Ohm is used to deliver mi- crowave signal to a TV antenna which has an impedance of 75 Ohm. What fraction of the signal (in terms of power) can be coupled into the antenna?
A three phase transmission line has conductors arranged in the corners of an equilateral triangle of side 0.03m. The radius of each of the conductor is 1.5 cm. Calculate the inductance for a length of 50 km. Select one: a. 55.33 nano Henry b. 55.93 milli Henry c. 55.48 micro Henry d. 55.84 micro Henry
1. a. A purely reactive load impedance Z₁ =jX terminates a transmission line. Prove that the reflection coefficient magnitude |K| is always unity, assuming the characteristic impedance Zo is real. What is the VSWR of the line in this case? b. Consider the transmission line in the figure. i. Determine the SWR on transmission line ii. The input impedance If=102, find I, in the figure. WC 100/0*V] 20 922 Air, lossless Z-50 £2 2.72 40 2 ele 3002
9.24 A three-phase, 60-Hz transmission line is completely transposed. The separation distances between conductors are 7, 7, and 10 m. Each conductor has a diameter of 5 cm. The line-to-line voltage is 138 kV, and the length of the transmission line is 100 km. Determine the following: a. Capacitance per phase b. Total capacitive reactance per phase C. Charging current taken by the total capacitance of the transmission line
Solve this math : A three-phase 60-hz transmission line has its conductors arranged in a triangular formation so that two of the distances between conductors are 20ft and the third is 40 ft. The conductors are ACSR Rook. Determine the capacitance to neutral in microfarads per mile and the capacitive reactance to neutral in ohm-miles. If the line is 115 mi long, find the capacitance to neutral and capacitive reactance of the line. Note: In the below i have added similer type of math and its ans.In the above math, there is just changes of values and Main Change is ACSR ROOK which is given to then question and in the below question which is solved it was ask ACSR Parakeet. So notice that. Follow This Book for help"POWER SYSTEM ANALYSISAND DESIGN;FIFTH EDITION, SI;J. DUNCAN GLOVER" Now solve the math according to the given way solve the math. "A three-phase 60-hz transmission line has its conductors arranged in a triangular formation so that two of the distances between conductors are 25…
The impedance of a transmission line with a length of 50 km is given as z = 0.08 + j0.48 22/km. At the end of the line, a power of 250 MW is drawn with a lagging power factor of cosy = 0.95 under 220 kV voltage. Under these conditions, find the voltage, current, and power factor at the beginning of the line.