A { in 2 in 40 KIPS in 1.5 in C 30 KIPS in 2 in D 34

Q: A steel (E = 210 GPa) bar is welded to a brass (E = 100 GPa) at C, and the ars are restrained by…

A:

Q: A single axial load of magnitude P = 58 kN is applied at end C of the brass rod ABC. Knowing that E=…

A: Load, P = 58 kNYoung's Modulus, E = 105 GPaDeflection of point C = 3 mm = 0.003From the figure,LAB =…

Q: Question (5): (a) The device shown in Fig. (5-a) is designed to apply pressure when bonding laminate…

A:

Q: Problem 1 Determine reactions RA, and RB. A distance between Point A and B is 19ft. Point A is a…

A:

Q: Problem 1. (18%) Knowing that the tension in wire BD is 650 N, determine the reaction at the fixed…

A:

Q: Cable BAC passes through a frictionless ring A and is attached to fixed supports at Band C, while…

A:

Q: 75 Ib 10 in. 10 in. 12 in.

A:

Q: Determine the reactions at A and B when 0 = 55°. 250 mm 150 mm C A 90 mm D

A:

Q: Question (1): Two cylindrical rods, AC made of aluminum and CD made of steel, are joined at C and…

A:

Q: The 4-mm-diameter cable BC is made of a steel with E= 200 GPa. Knowing that the maximum stress in…

A: Given:Cable diameter = 4mmE =200 GPaMax Stress 190

Q: A couple M of magnitude 1500 N·m is applied to the crank of an engine. For the position shown,…

A: Given data: The magnitude of applied couple, M = 1500 N-m. The cross sectional area of the…

Q: A vibration isolation unit consists of two blocks of hard rubber bonded to a plate AB as shown. A…

A:

Q: 2.39 Two cylindrical rods, AC made of aluminum and CD made steel, are joined at C and restrained by…

A:

Q: The aluminum rod AD is fitted with a jacket that is used to apply a hydrostatic pressure of 5000 psi…

A:

Q: 2. A 6-m-long pole AB is placed in a hole and is guyed by three cables. Knowing that the tensions in…

A:

Q: 250 mm

A: Given that, The force P=360 N,Q=480 N, The free-body diagram of the cable is as shown below,

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.