The aluminum rod AD is fitted with a jacket that is used to apply a hydrostatic pressure of 5000 psi to the 12-in. portion BC of the rod. Knowing that E = 10.1 × 106 psi and v = 0.36, determine the forces that should be applied to the ends A and D of the rod if the axial strain in portion BC of the rod is to remain zero as the hydrostatic pressure is applied. Determine the forces that should be applied to the ends A and D if the total length AD of the rod is to remain unchanged.

Q: Determine the mass of the heaviest uniform cylinder that can be supported in the position shown…

A: Determine the mass of the heaviest uniform cylinder that can be supported in the position shown…

Q: Question 4 (3 points) R1 R2 + 18 V

A:

Q: Problem 6. The framework is supported by the member AB which rests on the smooth floor. When loaded,…

A:

Q: If cables BD and BC can withstand a maximum tensile force of 17 kN, determine the maximum mass of…

A:

Q: 4. The rigid bar ABCD is supported by a pin at B and restrained by identic al ste el bars at C and…

A: First of all, make a FBD of the diagram as shown below.

Q: D 4.8 in. C 1.84 in. B 0.8 in. 5.6 in. 2.4 in. 1.6 in. Fig. P4.43 and P4.44 4.44 A parabolic slot…

A:

Q: The rectangular plate of sides 560 mm x 1590 mm is supported by hinges along its side BC and by the…

A: Given data,the rectangular plates of sides = T=540 N

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.