2) A cylindrical tank of cross-sectional area 25m2 is continuously fed with water through afeed pipe located at the top of the tank at avolumetric flow rate of 180 m3 /s, and the tank isgetting filled up with water at a speed of 7 m/s.If the tank has an open discharge pipe at thebottom, calculate the discharge flow ratethrough the discharge pipe.?

Introduction: When water enters through the intake pipe and escapes at the same moment, a portion…

A cylindrical tank of cross-sectional area 25 12 is continuously fed with water through a eed pipe located at the top of the tank at a olumetric flow rate of 180 m3/s, and the tank is etting filled up with water at a speed of 7 m/s. the tank has an open discharge pipe at the ottom, calculate the discharge flow rate hrough the discharge pipe.?

A cylindrical tank of cross-sectional area 25 12 is continuously fed with water through a eed pipe located at the top of the tank at a olumetric flow rate of 180 m3/s, and the tank is etting filled up with water at a speed of 7 m/s. the tank has an open discharge pipe at the ottom, calculate the discharge flow rate hrough the discharge pipe.?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Give answer soon please
Solve with me time 30 minutes
i need the answer quickly
What is the Reynolds # of the flow.? Water @ 15C is transported from a large open tank to the bottom of another open tank above. The surfaces of the two tanks are kept at 160ft apart vertically. The pipes used have an ID of 3.5 inches, and a total length of the pipe used is 150ft. In the system, there are two fully open gate valves, 6 90° elbows, and 2 standard tees. The pump used has a mechanical efficiency of 60%, and the volumetric flow rate of water is at 35 (ft^3)/s. Assume frictional losses frm sudden contraction and expansion are negligible.
In a 225 mm pipeline 0.14 m3/s of water are pumped from a reservoir of surface elevation30 over a hill of elevation 50. A pump of what power is required to maintain a pressure of 345kPa on the hilltop if the head lost between reservoir and hilltop is 6 m?
Water flows in a new 10 cm diameter cast iron pipe with f= 0.027 at a velocity of 1 m/s. For a pipe length of 500m , find the loss of head, a.3.44 m. b.0.88 m. c.1.72 m. d.6.88 m.
I need the answer as soon as possible