A 61 m rm of 203.2 mm pipe carrying 7.03 kg/cm^2 ga steam is drained by one steam trap. Find the capacity, kg per hr for running operation. The pipe is covered with insulation of 0.962 efficiency and is laid in a trench where the ambient ai temperature is probably 54.4 °C.

Q: Compressed liquid

A: Given Data: The pressure of liquid water at the inlet of the steam generator is, P1=10 MPa. The…

Q: The heat transfer Q from the steam turbine shown in figure below is 0.085 MW. Determine the power…

A: Given, Total heat loss = Q˙ = 0.085 MW = 85 × 103 W Pressure at inlet = P1 = 20 bar = 2000 kPa…

Q: 35-C) 4- Single cylinder double acting air compressor with stroke volume of (400cm³) and clearance…

A: Volumetric efficiency is defined as the ratio of Actual volume flow rate to the swept volume flow…

Q: Consider a heat pump cycle operating with R134-a fluid at 0.01kg/s mass flow rate. Conditions are…

A: First, find the properties of refrigeration at a given temperature and pressure from the chart.

Q: The diameter of the tube is 25 mm. The specific heat of water is 4.18 kJ/kg.°C. The overall heat…

A: There is a coma in mass flow rate data instead of point. I am considering it as 1.8 kg/s. If it is…

Q: water at 366 k is transfer from storge tank to another at rate 50 m3/min .The pump supplied work at…

A:

Q: heated from 50 C to 75 C by an oil flowing through the tube.. The oil enters at 115 °C and leaves at…

A:

Q: Designs the water pipe system for discharge line only with total pressure drop in a closed water…

A: Given that It is to Design the water pipe system for discharge line only with total pressure drop…

Q: 3- Discuss the siphon process and what benefit of it?

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 3. Steam entera a turtsine with a and specific enthalpy (e990 KT/ng).The steam leaves t. turbine…

A:

Q: 1. Given: A pipeline connecting a reservoir with a pump. Properties of the pipeline: L= 450 m; D=…

A: Given Data ; L=450 M D=0.4M ∈=0.5mm Q=380l/s we know that  Q=AV V=Q/A =380×10-3π4×0.42 =3.02 M/sec

Q: The Figure shown below is a parallel pipeline system with two branches used to supply lubricating…

A:

Q: The diameter of the tube is 25 mm. The specific heat of water is 4.18 kJ/kg.°C. The overall heat…

A:

Q: An electric motor drives a gearbox of a conveyor belt via a fluid coupling. The motor delivers 40 kW…

A: Given data as per question Power=40 kw=40×103 wspeed =1550 rpmη=96%loss =4%we know thatP=2πNT60…

Q: solve the problem

A: Step 1: To solve the given problem for a tube-in-tube heat exchanger with crude oil and another…

Q: In a gas urbine unit. the gases flow through the turbine is 15 kg's aud the power developed by the…

A: We have to slove

Q: Blowing air from 3 separate vents to a car gallery where the indoor air temperature is 22 °C and the…

A:

Q: Problem 2.) An intercooler discharges heat of 50 KW from the system. Determine the temperature of…

A: Given data: The specific heat of water is

Q: A pump with an efficiency of 15mm% is used to pump water from a tank (stationary water inside) at…

A:

Q: Water Bows through an adabatic pumping system at a steady fow ate (h) of a kt/ The conditions at the…

A: Given: For compressor, The mass flow rate of water, m = 3 kg/s The inlet pressure, P1 = 90 kPa The…

Q: An adiabatic open feedwater heater an electri power plant micer 0.2 Kals cf steam at l00nPa and…

A:

Q: Figure below shows the heat flux flowing across the area, Ay, creating temperature at the surfaces…

A:

Q: What is the friction factor when you have water at 20 deg C flowing through a cast iron pipe with a…

A:

Q: A pump draws saturated water from a condenser whích is maintained at 32.15°C. The friction head…

A: NPSh= Net Positive Suction HeadNPSH=(Total suction head)-(vapour pressure…

Q: Warm water in a geothermal heating system enters the pipe of a radiator at 20 psia and 108°F with a…

A: Notice that the condenser area incorporates both the high temp water and space radiator and station…

Q: 4.) Consider a large industrial HVAC duct with a diameter of 1 m that flows air at a pressure of 100…

A:

Q: ou are designing an electric air heater for large conference rooms. A 75mm OD, 4mm wall thickness…

A: Given Data: The outer diameter of the pipe is D = 75 mm. The wall thickness of the pipe is t= 4 mm.…

Q: Q: A condenser consists of a number of metal pipes of outer diameter 0.025m and thickness 0.003m.…

A:

Q: Q2: Find the cooling load of a barber shop due to infiltration and ventilation. The inside…

A: Given data Inside room outside room DBT=24°C DBT=48°C Relative humidity =50% Relative…

Q: Water at 15°C is pumped from a reservior at a rate of 0.1131 m3/s where the local atmospheric…

A:

Q: Given :take P1 = 10 KPa  Turbine entry conditions = 16 MPa and 600 oC(Degrees Celsius) Turbine…

A: Data given-  P1 = 10 KPa  Turbine entry conditions = 16 MPa and 600°CTurbine output=5 MPaPhase state…

Q: Leftover air at 20ºC and 100kPa is driven by a fan through a horizontal galvanized conduit of 1 m in…

A:

Q: A air Compressor lequires a power input Of1400 kW andk It operates adialatically. The air is…

A: Given Data The power input of the compressor is:P=1400 kW The intial temperature is:T1=300K The…

Q: Water stands at a constant elevation of 100 m in a tank feeding water at a constant rate of o m's in…

A:

Q: The clean U for an exchanger is 770 BTU/(hr 0 F ft2).  Its tube area is 550 ft2.  After operating…

A: Heat exchanger: It is a system used which is used to transfer heat between two or more than fluids.…

Q: A hydraulic vane pump running at 1800 rpm develops 2 L/s flow at 750 kPa. Volumetric efficiency is…

A: Given         Flow rate, Q = 2 L/s              Speed, N = 1800 rpm Overall efficiency = 0.8  Find…

Q: In a steam power plant, stream is to be condensed in the condenser at a temperature of 50°C and hfg…

A:

Q: 4. The following heat exchanger uses 10 kg/s of hot air to heat and boil liquid water into saturated…

A: The mass flow rate of air is The inlet temperature of air is The exit temperature of air is The…

Q: Given • 1 million people in Hong Kong using low-flush toilet and low- flow shower head. • 1 million…

A: Rate of CO2 production= 1.83 kg/kg of coal To find: 3. How much CO2 we can reduce?

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.