A 17 Hp motor is used to drive an oil pump with a discharge of 17 liters per second. The oil has a relative density of 0.83. Compute the hydraulic efficiency in % if the total head that the pump can deliver is 170 inHg a. 77.2 b. 80.2 c. 83.2 d. 86.2

Q: A centrifugal pump delivers 2.5 cfs of water against a head of 25 ft at 1500 rpm and requires 10 hp.…

A:

Q: During a test run of a Pelton wheel turbine, the pressure at the nozzle was 2.25 MPa when water…

A: GivenP=2.25MPaQ=1.7m3/sd=600mm =0.6m

Q: A pump moves water horizontally at a rate of  0.02 m^3  /s. Upstream of the pump, where the pipe…

A:

Q: Hydraulic pump calculations Pressure = 600 PSI Displacement (D) = 0.4in3/rev 1150 RPM Total…

A: The given data in the question is: Pressure = 600 PSI Displacement (D) = 0.4 in3/rev Speed = 1150…

Q: 2. A water is flowing out of the pipe and nozzle when the pressure at point A is 55 kPa where the…

A: Given data  Diameter at A = 200mm  Pressure at 55 kPa  Find the velocity at A  Discharge coming out…

Q: 6. A fabricated assembly made from three different sizes of standard steel tubing is shown below.…

A:

Q: A 10-in. x 6-in. x 12-in. duplex direct-acting steam pump operating at 35 strokes per minute…

A: Given data: The volume of the pump, V=10 in×6 in×12 in. The speed of the pump, N=35 strokes/min.…

Q: A pump develops a power of 50 KW at 300 rpm with fluid specific gravity of 1.02 when impeller…

A: GIVEN DATA - FOR PUMP -1 Power P=50KW  , N =300 rpm , D=150mm , Sp. Gravity = 1.02 FOR PUMP-2 POWER…

Q: Find the specific speed of a double suction centrifugal pump delivering 1.5 m³/s against a net head…

A: Data given -  double suction centrifugal pump   Q = 1.5 m3/s  For the double suction pumps the…

Q: 5. A water pipe having a 2.5 cm inside diameter carries water into the basement of a house at a…

A: As per given question we  defind a)speed  b) water pressure at the second floor?

Q: 6. A pump draws water from a sump through a vertical 6" pipe. The pump has a horizontal discharge…

A:

Q: If the velocity of water is 8 m/s and the pressure is 140 kPa on the discharge side of a pump. a.…

A:

Q: In the figure shown, it is desired to pump 40 L/s of water from a natural stream to a small…

A: INTRODUCTION: When water flows through the pipe, the head loss is inevitable. Minor and significant…

Q: 19. Find the loss of head in the pipe entrance if speed of flow is 10 m/s. OA. 5.10 m OB. 10.2 m O…

A:

Q: Solve fast with Proper Equation. 1. A centrifugal pump delivers 2.5 cfs of water against a head of…

A:

Q: Q No. 5: The diameter of side of a pump is 6 inches and that of the intake pipe is 8 inches. The…

A: According to the given information we have a diameter of the side pump is  D2  6inches =0.5 ft…

Q: Use the Goulds Pump Selection System to find a pump capable of delivering at least 500 gpm against…

A: To solve the given problem, we will use the Goulds Pump Selection System. This system helps us…

Q: A pump operates at 2000 rpm and delivers 200 gal/min at 90 ft head. The water distribution operator…

A: N1=Initial a Pump Speed=2000 rpmQ1=Pump Initial Flow rate=200 gal/minH1=Initial Pump Head=90…

Q: A pump delivers 5000 gallons per minute of fluid with specific gravity of 0.9 at a head of 100ft.…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.