A 1.00 liter solution contains 0.48 M ammonia and 0.37 M ammonium bromide. If 0.18 moles of perchloric acid are added to this system, indicate whether the following statements are true or false. (Assume that the volume does not change upon the addition of perchloric acid.) A. The number of moles of NH3 will remain the same. B. The number of moles of NH4+ will increase. C. The equilibrium concentration of H3O+ will remain the same. D. The pH will decrease. E. The ratio of [NH3] [NH4+] will increase.

A 1.00 liter solution contains 0.48 M ammonia and 0.37 M ammonium bromide. If 0.18 moles of perchloric acid are added to this system, indicate whether the following statements are true or false. (Assume that the volume does not change upon the addition of perchloric acid.) A. The number of moles of NH3 will remain the same. B. The number of moles of NH4+ will increase. C. The equilibrium concentration of H3O+ will remain the same. D. The pH will decrease. E. The ratio of [NH3] [NH4+] will increase.

Introductory Chemistry: A Foundation

9th Edition

ISBN:9781337399425

Author:Steven S. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Donald J. DeCoste

Chapter17: Equilibrium

Section: Chapter Questions

Problem 56QAP: . Which of the following will affect the total amount of solute that can dissolve in a given amount...

See similar textbooks

Similar questions

Consider a 1.50-g mixture of magnesium nitrate and magnesium chloride. After dissolving this mixture in water, 0.500 M silver nitrate is added dropwise until precipitate formation is complete. The mass of the white precipitate formed is 0.641 g. a. Calculate the mass percent of magnesium chloride in the mixture. b. Determine the minimum volume of silver nitrate that must have been added to ensure complete formation of the precipitate.
In Exercise 12.49, what is the allowed concentration of AgCl in g per 100 g of water? The Safe Drinking Water Act of 1974 established the maximum permitted concentration of silver ion at 0.05 ppm. What is the concentration of Ag+ in parts per million in a saturated solution of AgCl? (NOTE: 1 ppm = 1 mgofsolute/L of solution.)
Which of the following will affect the total amount of solute that can dissolve in a given amount of solvent? a. The solution is stirred. b. The solute is ground to fine particles before dissolving. c. The temperature changes.
Consider 1.0 L of an aqueous solution that contains 0.10 M sulfuric acid to which 0.30 mole of barium nitrate is added. Assuming no change in volume of the solution, determine the pH, the concentration of barium ions in the final solution, and the mass of solid formed.
Three acid samples are prepared for titration by 0.01 M NaOH: 1 Sample 1 is prepared by dissolving 0.01 mol of HCl in 50 mL of water. 2 Sample 2 is prepared by dissolving 0.01 mol of HCl in 60 mL of water. 3 Sample 3 is prepared by dissolving 0.01 mol of HCl in 70 mL of water. a Without performing a formal calculation, compare the concentrations of the three acid samples (rank them from highest to lowest). b When the titration is performed, which sample, if any, will require the largest volume of the 0.01 M NaOH for neutralization?
Use the solubility rules (Table 4.1) to decide which of the following compounds are expected to be soluble and which insoluble. a Mg(C2H3O2)2 b NiS c Cr(NO3)2 d Ca3(PO4)2
Solubility and Solubility Product You put 0.10-mol samples of KNO3, (NH4)2S, K2S, MnS, AgCl, and BaSO4 into separate flasks and add 1.0 L of water to each one. Then you stir the solutions for 5 minutes at room temperature. Assume that you have 1.0 L of solution in each case. a Are there any beakers where you would observe solid still present? How do you know? b Can you calculate the potassium ion concentration, K+, for the solutions of KNO3 and K2S? If so, do the calculations, and then compare these K+ concentrations. c For the solutions of (NH4)2S, K2S, and MnS, how do the concentrations of sulfide ion, S2, compare? (You dont need to calculate an answer at this point; just provide a rough comparison.) Be sure to justify your answer. d Are there any cases where you need more information to calculate the sulfide-ion concentration for the solutions of (NH4)2S, K2S, and MnS from part c? If so, what additional information do you need? e Consider all of the solutions listed at the beginning of this problem. For which ones do you need more information than is given in the question to determine the concentrations of the ions present? Where can you find this information? f How is the solubility of an ionic compound related to the concentrations of the ions of the dissolved compound in solution?
What mass of solid AgBr is produced when 100.0 mL of 0.150 M AgNO3 is added to 20.0 mL of 1.00 M NaBr?
Calculate the sodium ion concentration when 70.0 mL of 3.0 M sodium carbonate is added to 30.0 mL of 1.0 M sodium bicarbonate.
93. Calculate the mass of AgCl formed, and the concentration of silver ion remaining in solution, when 10.0 g of solid AgNO3is added to 50. mL of 1.010-2M NaC1 solution. Assume there is no volume change upon addition of the solid.
A 100.0-mL aliquot of 0.200 M aqueous potassium hydroxide is mixed with 100.0 mL of 0.200 M aqueous magnesium nitrate. a. Write a balanced chemical equation for any reaction that occurs. b. What precipitate forms? c. What mass of precipitate is produced? d. Calculate the concentration of each ion remaining in solution after precipitation is complete.
Consider the following two acids: In two separate experiments the pH was measured during the titration of 5.00 mmol of each acid with 0.200 M NaOH. Each experiment showed only one stoichiometric point when the data were plotted. In one experiment the stoichiometric point was at 25.00 mL added NaOH, and in the other experiment the stoichiometric point was at 50.00 mL NaOH. Explain these results. (See Exercise 113.)