A 0.025 M solution of an unknown organic acid has a pH of 5.70. 2.1 By means of a full calculation, determine the value of the ionisation constant of the conjugate base of this acid. You may use “HA" to denote the formula of the acid. - You may make certain assumptions to simplify your calculations 2.2 A certain amount of the sodium salt of the conjugate base of the acid was added to the system. Will the pH of the resulting solution increase or decrease, compared to the original given value? Explain your answer in a short sentence or two.

A 0.025 M solution of an unknown organic acid has a pH of 5.70. 2.1 By means of a full calculation, determine the value of the ionisation constant of the conjugate base of this acid. You may use “HA" to denote the formula of the acid. - You may make certain assumptions to simplify your calculations 2.2 A certain amount of the sodium salt of the conjugate base of the acid was added to the system. Will the pH of the resulting solution increase or decrease, compared to the original given value? Explain your answer in a short sentence or two.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A solution is prepared at 25 °C that is initially 0.29M in chloroacetic acid (HCH,CICO,), a weak acid with K,=1.3 × 10 and 0.34M in sodium chloroacetate (NaCH,CICO,). Calculate the pH of the solution. Round your answer to 2 decimal places. pH = 0 ?
Calculate the change in pH when 5.00 mL of 0.100 M HC1(aq) is added to 100.0 mL of a buffer solution that is 0.100 M in NH, (aq) and 0.100 M in NH,Cl(aq). Consult the table of ionization constants as needed. 4 ApH = Calculate the change in pH when 5.00 mL of 0.100 M NAOH is added to the original buffer solution. ApH :
In the laboratory, a general chemistry student measured the pH of a 0.386 M aqueous solution of ethylamine, C,H&NH, to be 12.094. Use the information she obtained to determine the K, for this base. K(experiment)- In the laboratory, a general chemistry student measured the pH of a 0.587 M aqueous solution of trimethylamine, (CH,),N to be 11.768. Use the information she obtained to determine the K, for this base. K,(experiment) =
(a) Using the expression Ka=[H+][A−]/[HA], explain how to determine which solution has the lower pH, 0.10MHF(aq) or 0.10MHC2H3O2(aq). Do not perform any numerical calculations. (b) Which solution has a higher percent ionization of the acid, a 0.10M solution of HC2H3O2(aq) or a 0.010M solution of HC2H3O2(aq) ? Justify your answer including the calculation of percent ionization for each solution.
0.0200 moles of hydroiodic acid was mixed with 500.0 mL of water. Calculate the pH of the solution. Express your answer in THREE significant figures
Use the following information as a guide to help answer the next three questions. Your answer MUST be in the same format. Indicators can be used to help approximate the pH of a solution based on the indicator colour. Here is an example of how to word the pH approximation for bromothymol blue. Indicator Colour pH approximation Yellow 6.0 and below Green between .0 and 7.6 6. Blue 7.6 and above A Chemistry experiment is done where the pH of various solutions are tested, using indicators. The colours of indicators are recorded as shown below. Using the method outlined above in the example of bromothymol blue, indicate what the colours of the indicators tell us about the pH approximation of the solution. Values and wording are very important, so be precise. Be sure to word your pH approximation as outlined in the example. Indicator Colour pH approximation methyl red orange Indicator Colour pH approximation phenolphthalein colourless Indicator Colour pH approximation phenol red red
An analytical chemist is titrating 219.9 mL of a 0.5100 M solution of aniline (CH,NH,) with a 0.1800 M solution of HNO,. The p K, of aniline is 9.37. 3 Calculate the pH of the base solution after the chemist has added 360.5 mL of the HNO, solution to it. Note for advanced students: you may assume the final volume equals the initial volume of the solution plus the volume of HNO, solution added. Round your answer to 2 decimal places.
Explain the chemistry behind the difference of pH between normal rainwater and acid rain. Please answer concisely.
Limestone is a common rock used for road constructions. A construction company extracted 5 tons of the rock near a river on a rainy season. The rain washed away 2% of the rock into a nearby river which flows to a 10 acre and 15 feet deep lake in the area. With the help of relevant chemical equations, data, and calculations, explain how the washing of the rocks into the lake alters the pH of the lake.explain calculations of the final expected pH of the water in the lake
A solution is prepared at 25 °C that is initially 0.14M in benzoic acid (HC, H, CO,), a weak acid with K=6.3 × 10 and 0.41M in potassium benzoate (KC H, CO,). Calculate the pH of the solution. Round your answer to 2 decimal places. pH = 0
using the simultaneous equation method. please answer fully
Calculate the change in pH when 7.00 mL of 0.100 M HCl(aq) is added to 100.0 mL of a buffer solution that is 0.100 M in NH, (aq) and 0.100 M in NH Cl(aq). Consult the table of ionization constants as needed. ApH = Calculate the change in pH when 7.00 mL of 0.100 M NaOH is added to the original buffer solution. ApH = OCT 12 MacBook Pro Question Source: McQuarrie, Rock, And Gallogly 4e - General Chemistry | Publisher: Unive LI A