Consider the titration of 100.0 mL of 0.100 M acetic acid (Ka = 1.8 x 105). When 50.00 mL of 0.100 M NaOH is added to the acetic acid solution, calculate the pH of the resulting mixture. Use the simultaneous equations method, showing the derivation of the final equation you used to calculate pH and justify any assumptions made in your derivation.

Q: What are two characteristics of good recrystallization solvent for given compound

A: Recrystallization is the most important process to purify the non volatile solvent.

Q: Question attached

A: Ionic strength (Electrolyte strength) of a compound is given by: μ=12×∑concentration×Charge2  1)…

Q: Listed below you have been given a focus question that must be answered using a well-rounded…

A: General chemistry

Q: Show ALL your steps and details in your calculations, by using GRASPS: Given, Required, Analysis,…

A:

Q: In HPLC, the is always a liquid. a) mobile phase b) stationary phase c) solute

A: HPLC (high performance liquid chromatography) is an analytical technique to separate mixture of…

Q: My Professors asked me to make a standard curve for Gallic acid and she asked me to follow the…

A: To create a standard curve for Gallic acid, we would typically follow these steps:Preparation of…

Q: Describe chromatography. Include the following words: Physical change, Intermolecular Forces,…

A: physical change: A change in the physical condition and  properties of substance that is change.…

Q: Soluble Hydrophobic Heterogeneous Hydrogen Dispersion bonding Molecular Miscible Immiscible Solution…

A: solution- A homogeneous mixture of two or more substances heterogeneous mixture- a mixture with two…

Q: If all of the unknown solid does not dissolve, would the calculated molecular mass be too high or…

A: We put a measured mass of an unknown solid in the measured mass of a known solvent to find the…

Q: 5. You are heating a mixture of (flammable) cyclohexane and toluene in a round bottomed flask. What…

A: Mixture: A mixture can be defined as the substance which will be made by more than one various kinds…

Q: A helium balloon takes up 4.35 liters of space. Your friend is showing off his new chemistry skills…

A: Dimensional analysis is the practice of checking relations between physical quantities by…

Q: 7. What are the possible sources of error in this experiment?

A: Incorrect concentration determination when concentration of Fe3+ is more than that of Fe2+. The…

Q: From the model define solute, solvent and solution. Which can be measured directly- the volume of…

A: Solution is a mixture of solute and solvent. Solute is present in less amount while solvent is…

Q: Graduated Plastic Pipet 1. Mass a small, empty, dry beaker and record to 0.01g. 2. Using a clean…

A: Percent error is the calculation of percentage of an erroneous calculation.

Q: the percent sugar for both label and graph are correct and if the percent error is correct as well.

A: a)Formulas:Density(g/ml)=massvolume(ml)Mass(g)= Density(g/ml)×volume(ml)Percent error:-  the…

Q: In this experiment, the eluant is O 1) petroleum ether O 2) water 3) dichloromethane 4) ethyl…

A: In the given question we have to choose the correct eluent used in the column chromatography.…

Q: Why is it impossible to perform an experiment where you would interpolate a value for absolute zero?

A: We have to tell why is it impossible to perform an experiment where you would interpolate a value…

Q: Filter paper can be added to the developing chamber to help saturate the chamber with solvent vapor.…

A: Answer: True Thin-layer chromatography is a technique for separating a sample into its component…

Q: 20 minutes into eluting his column, a student has not yet observed the orange ferrocene move near…

A: To explain the reasoning of the given column chromatography problem.

Q: Think about the situation where you are investigating the relationship of study time vs. exam grade.…

A: Few questions about data interpretation, which is to be accomplished.

Q: What are the units of an amount taken as a log. For instance, we were asked to plot a standard curve…

A: "Log" of any value is constant, however we can take "log" of any positive value having any unit.

Acid Base Titration

An acid-base titration is the method of quantitative analysis for determining the concentration of an acid and base by exactly neutralizing it with a standard solution of base or acid having known concentration.