Will 260.0 milligrams of calcium carbonate raise the pH of 75.0 milliliters of stomach fluid from a low pH of 1.00 into the normal pH range of 1.50-3.50? In the last discussion, you calculated that 260.0mg of calcium carbonate is 0.2600g of calcium carbonate. The next step is to figure out the formula of calcium carbonate and to calculate the molar mass of calcium carbonate in grams per mole. Submit a reply that that tells how you decided to approach the problem and shows the work that results in an answer. Use correct units and significant figures and correct symbols for elements and math. In addition, select another student's explanation that makes sense to you and reply with a comment about the insight you gained from their answer. Calcium carbonate is an ionic compound. Ionic nomenclature is in section 2.8. Molar mass is described on page 74 in section 2.8 of the textbook.

Will 260.0 milligrams of calcium carbonate raise the pH of 75.0 milliliters of stomach fluid from a low pH of 1.00 into the normal pH range of 1.50-3.50? In the last discussion, you calculated that 260.0mg of calcium carbonate is 0.2600g of calcium carbonate. The next step is to figure out the formula of calcium carbonate and to calculate the molar mass of calcium carbonate in grams per mole. Submit a reply that that tells how you decided to approach the problem and shows the work that results in an answer. Use correct units and significant figures and correct symbols for elements and math. In addition, select another student's explanation that makes sense to you and reply with a comment about the insight you gained from their answer. Calcium carbonate is an ionic compound. Ionic nomenclature is in section 2.8. Molar mass is described on page 74 in section 2.8 of the textbook.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

7 A 0.336 M solution of an acid, HA, has a pH = 2.85. What is the value of the ionization constant K, for this acid? Report your answer with scientific notation with 2 places past the decimal point. Use this format for scientific notation: 1.23*10^-1 Type your answer...
1.00g of acetylsalicylic acid is mixed with 120 mL of water. Then, 25.00 mL of the solution is transferred to 3 flasks each. Assuming the pH is 3.00, calculate the initial concentration of , the Ka and pKa.
A 0.1-L unbuffered solution needs the pH adjusted from 4 to 1. How many microliters of a 12 molar HCl solution need to be added to adjust the pH? Report your answer to four decimal places. For this question: Assume the volume of HCl being added is negligible and the total volume of the solution does not change. The volume of the solution is *not* 1 L like it was in the practice pools. The question requests your answer be reported in μL (microliters)!!
Suppose a 0.14 M aqueous solution of oxalic acid (H₂C₂O₂) is prepared. Calculate the equilibrium molarity of CO,. You'll find information on the properties. of oxalic acid in the ALEKS Data resource. Round your answer to 2 significant digits. M D.P X S
Each row of the table below describes an aqueous solution at 25 °C. The second column of the table shows the initial components of the solution. • Use the checkboxes in the third column to explain the type of the initial solution. The fourth column describes a change in the solution. • Use the fifth column to predict how the change in the solution will change its pH. alo initial type solution initial components (check all that apply) effect of change on pH change (check one) O acidic pH higher H,0 basic add H C10, O pH lower A O neutral O pH the same acidic O pH higher H,0 add Na ClO, B O basic O pH lower O neutral pH the same O acidic pH higher Н, 0, КОН V basic add H Br O pH lower O neutral O pH the same O acidic O pH higher D Н,о, КОН O basic add K Br O pH lower O neutral pH the same Explanation Check © 2021 McGraw Hill LLC. All Rights Reserved. Terms of Use | Privacy Center Accessibility
A student is asked to design an experiment that uses indicators to identify which of three unknown solutions labelled X, Y, and Z have pH values of 1.3, 5.7, and 6.9. The student must select a maximum of four indicators from the following list to perform the experiment. 1. orange IV 2. phenolphthalein 3. bromocresol green 4. alizarin yellow R 5. bromothymol blue 6. chlorophenol red 7. cresol red 8. indigo carmine The indicators that will allow the student to identify successfully the pH of the unknown solutions are and List the numbers from lowest to highest.
Human blood is slightly basic. Calculate the hydroxide ion concentration in a sample of blood with a pOH of 6.49You MUST show your work.Record your answer in scientific notation with the proper number of significant digits and proper units For each of the following pH values, provide the correct corresponding pOH value. Remember that answers must be provided to the correct number of significant digits..pH value of 4.4 will have a pOH value of Answer pH value of 2.9 will have a pOH value of Answer pOH value of 10.24 will have a pH value of Answer pOH value of 8.1 will have a pH value of Answer
If a person is taking part in strenuous activity or exercise, will this chemical equilibrium shift? If so, in what direction? Will the blood pH stay the same, increase, or decrease? Justify your reasoning and draw a concentration-time curve that represents this change
A buffer solution is prepared by combining 0.898 moles of formic acid and 0.733 moles of sodium formate. What will the solution pH be if 0.274 moles of sodium hydroxide (NaOH) is added to the buffer solution? The K₂ of formic acid is 1.8 x 104. (Two decimal places) Type your answer...
You have chosen Methylamine as your weak base in the buffer solution. You have already added enough of the conjugate acid salt to make the buffer solution concentration at 0.48 M in this salt. The desired pH of the buffer should be equal to 9.75. To prepare the buffer, a total volume of 550 mL is required. The stock solution of the weak base is available at 1 gallon with a concentration of 0.98 M. (Remember the lesson on dilution: C1V1=C2V2) 4. How many mL should be taken from the stock solution to prepare the desired buffer solution? (round off final answer to 1 decimal place)
4
Determine the pH of a solution that is 0.00411 M HCl and 0.0476 M HCIO₂. The K, of HCIO, is 1.1 x 10-². pH =