7.resistance):The practical capacitor can be simplified as the model below (ESR: equivalent series10 μFESRWFrom a datasheet, it is known that a 10 µF aluminum electrolytic capacitor has an impedance of2800 mOhm at the 100 kHz testing condition.(1) Calculate the ESR under the above testing condition;(2) Calculate the phase shift between the voltage and current at 100 Hz and 10k Hz sinusoidalexcitation conditions.

May this answer helpful to you.

Answered: 7. resistance): The practical capacitor…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

An inductor of 150hms and resistance of 10 Ohms are connected in series to a 230V, 50 Hz ac supply. Determine the active and reactive power and power factor in the circuit.
Pls. write solution neatly
Design of a DC-DC Converter. The Circuit Below shows a basic Buck-Boost Converter with a highly inductive Load. With a Deliberate mistake in the configuration of the Circuit Connection. The Value of L1 is 22mH, C1 is 10uF, R1 is 220 and L2 is 10mH. The circuit operates with a switching frequency of 20KHZ. The Duty cycle of the Clock signal V2 is given by the function below: ( 17 ) х0.2 Duty Cycle, k = 0. 55 + 100 Your Unique Duty Cycle = %3D Buck-Boost Converter Q1 IRG4BC10U D1 R1 222 1N4009 C1 LV1 12V L1 22mH 10µF L2 10mH a) Find the mistake in the configuration of the circuit and correct the connection error.
3. A sinusoidal waveform is displayed on a c.r.o. screen. The peak-to-peak distance is 5 cm and the distance between cycles is 4 cm. The 'time'switch is on 100 µs/cm and the 'volts/cm' switch is on 10 V/cm. Determine (i) angular frequency (ii) peak (iii) rms value of voltages (iv)Time period and (v) form factor.
Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
A series circuit consisting of a 50 – ohm resistor, 0.5 – henry inductor, and a 100 – microfarad capacitor is connected to a 110 – volt, 50 cycle source. Calculate the following: a.) TOTAL IMPEDANCE b.) CURRENT c.) VOLTAGE DROP ACROSS THE RESISTOR d.) VOLTAGE DROP ACROSS THE INDUCTOR e.) VOLTAGE DROP ACROSS THE CAPACITOR f.) AVERAGE POWER g.) APPARENT POWER h.) REACTIVE POWER i.) POWER FACTOR j.) POWER FACTOR ANGLE DRAW THE PHASOR DIAGRAM IF POSSIBLE AND ROUND OFF TO FOUR DECIMAL PLACES

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS