Determine the power radiated for the antenna has the following specifications (48 ohm radiationresistance, 2 ohm loss resistance and 50 ohms reactance) connected to generator with 12 V opencircuit and internal impedance 50 ohm via à long transmission line with 100 ohm characteristicimpedance.

If you have any doubt you can ask in comment section

Answered: Determine the power radiated for the…

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.32MCQ

See similar textbooks

Similar questions

Needs Complete typed solution with 100 % accuracy.
A coaxial cable with a characteristic impedance of 50 Ohm is used to deliver mi- crowave signal to a TV antenna which has an impedance of 75 Ohm. What fraction of the signal (in terms of power) can be coupled into the antenna?
4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY B. SERIES CONDUCTANCE AND SHUNT CAPACITANCE C. SHUNT CONDUCTANCE AND SHUNT CAPACITANCE D. SHUNT CONDUCTANCE ONLY
Please only answer 2 amd 3 please
The difference between envelope detection and synchronous detection is: a. 1DB b. 4DB c. 2DB d. 3DB
Obtain three zone setting for (i) a reactance relay and (ii) a mho relay of 60° from the following data: CT: 400/1 A PT: 132 kV/110 V Impedance for the first section is (2.5 + j5) ohms (primary) and that of second section (3.5 + j7) ohms (primary). The first zone covers 80% of the first section, the second zone covers the first section plus 30% of the second section and the third zone covers the first section plus 120% of the second section.
A three phase system with Dab Dbc one conductor per phase as shown in the figure. The conductors are stranded and spaced as shown, (Dab=Dbc=4m). The outside diameter of the phase conductor is 2cm. The GMR of the phase conductor is 0.7788 cm. The value of inductance per phase is: Select one: O a. (1.2445 * 10A-3) mH/km O b. (1.1559 * 10^-6) H/m O c. (1.4562 * 10A-6) H/m O d. (1.2945 * 10A-6) H/m O e. (1.2445 * 10A-6) H/m
Why is the negative effect of stray capacitance more pronounced in very high frequency circuits?
A parabolic reflector focuses electromagnetic waves into a beam as shown in the figure. The electromagnetic radiation is pulsed, with a pulse frequency of 16.0 GHz, and the duration of each pulse is t = 1.00 ns. The face of the reflector has a radius of 5.00 cm, and the average power during each pulse is 20.0 kW. (Due to the nature of this problem, do not use rounded intermediate values in your calculations-including answers submitted in WebAssign.) (a) What is the wavelength (in cm) of these electromagnetic waves? cm (b) What is the total energy (in µJ) contained in each pulse? (c) Compute the average energy density (in mJ/m³) inside each pulse. mJ/m³ (d) Determine the amplitude of the electric field (in kV/m) and magnetic field (in µT) in these electromagnetic waves. Emax kV/m %3D B max HT (e) Assuming that this pulsed beam strikes an absorbing surface, compute the force (in uN) exerted on the surface during the 1.00 ns duration of each pulse. µN
An antenna with a radiation resistance of 48 ohms, a loss resistance of 2 ohms, and a reactance of 50 ohms is connected to a generator with open-circuit voltage of 10 V and internal impedance of 50 ohms via a N4-long transmission line with characteristic impedance of 100 ohms. The power radiated by the antenna is ..... .. 0.1384w 0.1384dB 0.148dB 0.148w
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance

Recommended textbooks for you

Power System Analysis and Design (MindTap Course …

Electrical Engineering

ISBN:

9781305632134

Author:

J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:

Cengage Learning