6. In the balanced 3-phase system of Figure 2, determine the RMS phase and line voltages and currents in the resistors, the average power dissipated per phase and the total average power dissipated. Er = 169.7cos 62.8t. and ZR=ZY=ZB= 30 ANS:[120 V, 207.8 V, 4 A, 4 A, 480 W, 1440 W] %3D IR ERY EBR VR ZR ER IN EB Vs Vr Ey Ze z, ly En Is Thenn n

6. In the balanced 3-phase system of Figure 2, determine the RMS phase and line voltages and currents in the resistors, the average power dissipated per phase and the total average power dissipated. Er = 169.7cos 62.8t. and ZR=ZY=ZB= 30 ANS:[120 V, 207.8 V, 4 A, 4 A, 480 W, 1440 W] %3D IR ERY EBR VR ZR ER IN EB Vs Vr Ey Ze z, ly En Is Thenn n

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A source of AC emf E₁ = 100/00 volts with an impedance of Z₁ = 20/0° ohms is connected in parallel with another AC source of E₂ = 100/53.1º volts with an impedance Z₂ = 20/0° ohms. The two AC source are use to supply a load impedance of Z₁ = 20/-900 ohms. Calculate the value of the load current IL. O a. 10 amperes O b. 12 amperes O C. 4 amperes O d. 8 amperes
3.n Figure 3P.2 shows two capacitor banks, C, and C2, in a substation C is enercized, but C, is discharged. The three-phase, 60 Hz ratings of the banks are: C,, 5 MVA; C,, 3 MVA, on a 13.8 kV base. The source has a short circuit rating of 20 kA rms at 13.8 kV. The inductance of the loop between C, and C,, represented by L, is 30 µH. 13.8 kV V3 L L2 o to C2 Source Capacitor banks ouG OL 19 Fig. 3P.2. Calculate the peak transient voltage that will appear on C, and the peak transient current that will flow in L,, if the switch S is closed at the peak of the voltage cycle. Point out any assumptions you make.
The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical three- phase network of 380 V compound voltage. The loads are single phase. Load 1 absorbs an active power of 950 W with f.d.p. 0.5 inductive. Load 2 absorbs an active power of 1,140 W with f.d.p. Unit. Load 3 absorbs from the network an active power of 760 W with f.d.p. 0.5 capacitive. Taking the network voltage URN as the phase reference, calculate: a) complex expressions of the line currents IR. Is. and IT RO- SO- To- : IR Is IT UL-380 V CARGA 1 P₁ = 950 W cos p1=0,5 ind. CARGA 2 P₂=1.140 W cos p₂=1 CARGA 3 P3=760 W cos p3=0,5 cap.
please explain each part on paper thank you i will like
How about the average power on each elements? And is it absorbing or delivering power too?
Two relays each with 20-ohm resistance and 0.16-henry inductance are connected in series. What is the equivalent impedance?a. 20 + j102.2 ohms c. 20 + j95.32 ohmsb. 20 + j120.63 ohms d. 10 + j25.32 ohms
A load has a leading power factor. a) Is it a capacitive or inductive load? b) Is the reactive power positive or negative? c) Repeat for a load with lagging power factor
Impedances Z1 = 5.83 at angle of -59 deg. and Z2 = 8.94 at an angle of 63.43 deg. are in series and carry an effective current of 5A. Determine the Power and power factor of the circuit indicating if it is leading or lagging.
The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical three- phase network of 380 V compound voltage. The loads are single phase. Load 1 absorbs an active power of 950 W with f.d.p. 0.5 inductive. Load 2 absorbs an active power of 1,140 W with f.d.p. Unit. Load 3 absorbs from the network an active power of 760 W with f.d.p. 0.5 capacitive. Taking the network voltage URN as the phase reference, calculate: a) complex expressions of the line currents IR. Is. and IT RO- SO TO IR Is IT U₁-380 V CARGA 1 P₁ =950 W cos p1=0,5 ind. CARGA 2 P₂=1.140 W cos p₂=1 CARGA 3 P3=760 W cos p3=0,5 cap.
Please find Preal, Ptotal, and Pvar
Develop the mathematical relationships for the design of the inductance and capacitance of a three-phase double circuit line. A three-phase double circuit line consists of two identical three-phase parallel circuits as shown in the figure below. The circuits are operated with a1-a2, b1-b2, and c1-c2 in parallel.