6-72 Determine the resultant force at pins A, B, and C on the three-member frames Hint: use segments AC and BC. Then, using the two segments, develop equations in terms of Cx and Cy. Find Cx and Cy. Then plug back in to the other equations to find the rest of the unknowns. 200 N/m 60° C 2 m B 800 N 2 m

6-72 Determine the resultant force at pins A, B, and C on the three-member frames Hint: use segments AC and BC. Then, using the two segments, develop equations in terms of Cx and Cy. Find Cx and Cy. Then plug back in to the other equations to find the rest of the unknowns. 200 N/m 60° C 2 m B 800 N 2 m

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.15P: The structure is supported by a pin at C and a cable attached to A. The cable runs over the small...

See similar textbooks

Similar questions

2-38. The three forces are applied to the bracket. Determine the range of values for the magnitude of force P so that the resultant of the three forces does not exceed 2400 N. Problem 2-38 800 N 3000 N 90% 60° X D
2-13 The force acting on the gear tooth is F 20 tb. Resolve this force into two components acting along the lines aa and bb.
Q-4. Determine the "Horizontal Displacement" of Joint "A of the below given frame by using the "Method of Virtual Forces". 6 ft B 200 lb -6 ft- 8 ft
The 250-N block rests upon a level plane for which fk = 0.2. It is pulled by force P = 100N inclined at 20o with the horizontal. If the 100-N pull is then removed, find the distance the block will travel. the answer must 3 decimal places.
P = 93.3 N Determine the force at F. Take it apart to help you solve
5) Use the method of sections to find the true magnitude and direction in bar DB of the truss. Hint( Joint C is in equilibrium) В 45° F. 4' E 4' -100 Ibs
2-11. Determine the design angle 0 (0° s 0 = 90°) for strut AB so that the 800-N horizontal force has a compo- nent of 1000 N directed from A towards C. What is the component of force acting along member AB? Take = 40°, 4 = 800 N A B.
The bracket is held to the wall using three A-36 steel bolts at B, C, and D. Each bolt has a diameter of 0.5 in. and an unstretched length of 2 in. If a force of 800 lb is placed on the bracket as shown, determine how far, s, the top bracket at bolt D moves away from the wall. For the calculation, assume that the bolts carry no shear; rather, the vertical force of 800 lb is supported by the toe at A. Also, assume that the wall and bracket are rigid. A greatly exaggerated deformation of the bolts is shown.
Using the Method of Sections, find the forces in CE, CD, and BD. 4 m 5 KN B 2 m 10KN 4 m 3 m F
4-2) Find the megnitude and direction of the support forcas at A and B and the res tant mament
3/15 Find the angle of tilt e with the horizontal so that the contact force at B will be one-half that at A for the smooth cylinder. 45 45
W 6 ft A D -4 ft- + B -4 ft C Determine the normal force at point b using method of section if w = 52.1lb/ft