5. Long cylindrical aluminum rods (p = 2700 kg/m³ and C, = 0.973 k] /kg · K) of 5-cm diameter areheat treated from 20°C to an average temperature of 400°C by drawing them at a velocity of 8 m/minthrough a long oven. Determine the rate of heat transfer to the rods in the oven.

Given, ρ=2700 kg/m3 Cp=0.973 kJ/kg.K Diameter, d=5cm = 0.05 m T1=20°C T2=400°C Velocity , v=8 m/min…

Answered: 5. Long cylindrical aluminum rods p =…

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

To treat a burn on his hand, a person decides to place an ice cube on the burned skin. The mass of the ice cube is 16.8 g, and its initial temperature is -10.7 °C. The water resulting from the melted ice reaches the temperature of his skin, 29.4 'C. How much heat is absorbed by the ice cube and resulting water? Assume that all of the water remains in the hand. Constants for water can be found in this table.
3. (a) The rate of heat transfer through a wood shingles roof of 4.50 m length, 3.90 m width and in 8.50 cm thickness is 126.65 W. The temperature of outside and inside-surface is 33.5 °C and 26.5 °C, respectively. (i) Determine thermal resistance, R of the wood shingles roof. (ii) Calculate the thermal conductivity. Give your answer in 3 decimal places. (iii) If a glass wool with higher thermal resistance is used to replace the wood shingles roof, determine which material tend to have lesser rate of heat transfer.
Homework 3: Problem 9: An electric coffeemaker has a 790-W heating element. The specific heat of water is 4.19 × 103 J/(kg⋅°C). How long, in seconds, does it take the coffeemaker to heat 0.57 L of water from 18°C to 95°C, assuming all the heat produced by the heating element goes into the water? Δt = ______
The temperature of a 5.00-kg lead brick is increased by 525 C°. If the specific heat capacity of lead is 128 J/(kg.C°), what is the increase in the mass of the lead brick when it has reached its final temperature? O 5.80 × 10- -11 kg O 9.12 × 10-11 kg O 1.60 × 10-12 kg O 3.73 × 10-12 kg O 2.80 × 10-12 kg
A chunk of metal has a mass of 600g and has been in boiling water for several minutes. It is quickly dropped into an insulating Styrofoam beaker containing 1.20 kg of water at room temperature (20.0°C). After waiting few minutes, you observe that the water's temperature has reached a constant value of 23.0 °C. The specific heat of water is 4190 J/(kgK). a) Assuming that the Styrofoam absorbs a negligibly small amount of heat and that no heat was lost to the surroundings, what is the specific heat of the metal? b) If the heat absorbed by the Styrofoam actually is not negligible, what would be the specific heat of the metal? A)Greater than the one calculated in part (a). B)Smaller than the one calculated in part (a). C)Same as the one calculated in part (a).
1. (a) How much heat transfer is necessary to raise the temperature of a 0.26 -kg piece of ice from -20 °C to 130 °C, including the 20 kJ/s energy needed for phase changes? Specific heat of ice = 2.090 kJ/kg °C Specific heat of water = 4.186 kJ/kg °C Specific heat of steam = 1.520 kJ/kg °C Heat of fusion of water = 334 kJ/kg Heat of vaporization = 2256 kJ/kg (i) Heat needed to warm ice to 0 °C: Q₁: ✔KJ (ii) Heat needed to melt ice at 0 °C: Q₂: KJ (iii) Heat required to warm 0 °C water to 100 °C: Q3: KJ (iv) Heat required to vaporize water at 100 °C: Q4: KJ (v) Heat required to warm 100 °C vapor to 130 °C: Q5: KJ Total heat, Q: KJ (b) How much time is required for the entire process, assuming a constant 20.0 kJ/s rate of heat transfer? Total time, t: S
the surface area of a picnic cooler is 2.10 m^2 and it has walls constructed of a material 1.50 cm thick that has a thermal conductivity of 2.00 X 10^-2 W/(m x degrees celsius). If the temperatures inside and outside are 0.0 degress celsius and 28.5 degrees celsius, determine the rate of heat flow into the freezer and the time required to melt 2.50 kg of ice inside the cooler at 0.0 degrees celsius

Recommended textbooks for you

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

University Physics (14th Edition)

Physics

ISBN:

9780133969290

Author:

Hugh D. Young, Roger A. Freedman

Publisher:

PEARSON

Introduction To Quantum Mechanics

Physics

ISBN:

9781107189638

Author:

Griffiths, David J., Schroeter, Darrell F.

Publisher:

Cambridge University Press

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

University Physics (14th Edition)

Physics

ISBN:

9780133969290

Author:

Hugh D. Young, Roger A. Freedman

Publisher:

PEARSON

Introduction To Quantum Mechanics

Physics

ISBN:

9781107189638

Author:

Griffiths, David J., Schroeter, Darrell F.

Publisher:

Cambridge University Press

Physics for Scientists and Engineers

Physics

ISBN:

9781337553278

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

Lecture- Tutorials for Introductory Astronomy

Physics

ISBN:

9780321820464

Author:

Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina Brissenden

Publisher:

Addison-Wesley

College Physics: A Strategic Approach (4th Editio…

Physics

ISBN:

9780134609034

Author:

Randall D. Knight (Professor Emeritus), Brian Jones, Stuart Field

Publisher:

PEARSON

SEE MORE TEXTBOOKS

5. Long cylindrical aluminum rods p = 2700 kg/m³ and C, = 0.973 kJ/kg • K) of 5-cm diameter are heat treated from 20°C to an average temperature of 400°C by drawing them at a velocity of 8 m/min through a long oven. Determine the rate of heat transfer to the rods in the oven.