4. On a 20 cm paper chromatography plate, an analyte was spotted 1 cm from the bottom edge. The plate was developed until the solvent reached 1 cm from the top edge. Measuring from the spot, the analyte traveled 2.88 cm. Calculate the Rf of the analyte. O 0.16 0.15 0.22 0.14

4. On a 20 cm paper chromatography plate, an analyte was spotted 1 cm from the bottom edge. The plate was developed until the solvent reached 1 cm from the top edge. Measuring from the spot, the analyte traveled 2.88 cm. Calculate the Rf of the analyte. O 0.16 0.15 0.22 0.14

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: 15. A chromatography trial is performed on an unknown substance. The d₁ = 9.0 cm, the d2=13.7 cm.…

A: Thin layer chromatography (TLC) is a method of separating components of the mixture. It is based on…

Q: In molecular exclusion (size exclusion) chromatography, molecules have the the longest retention…

A: Molecular exclusion chromatography is base on size of molecules. It is a separation technique that…

Q: A chromatographic analysis is performed with a sample containing toluene and benzene. The column…

Q: The figure below shows a portion of a GC chromatogram for a mixture of two aromatic compounds…

A: To find out the retention time for component A and B given the following chromatogram. The…

Q: explain what a response ratio is in Gas Chromatography and why it might be needed to quantify…

A: Gas chromatography (GC) is an analytical technique used to separate the chemical components of a…

Q: Retention Time Area of Peak % of Total Identity Component 1 Component 2 Component 3

A: Given data:

Q: 5. Here, you can find an example of a paper chromatography experiment. Use the two Chromatograms…

A: Paper chromatography is a analytical Method to separate coloured components. A drop of a mixture…

Q: 2. Several standards were chromatographed, 0.5 1.0 2.0 Conc (ug/ml) Peak area 5.0 10.1 17.2 and the…

A: The graph is to be plot by taking concentration(μg/mL) in X-axis and peak area in Y-axis.

Q: A solute has a retention time of 5.4 min with a width at half height of 0.41 min on a column 12.2 m…

Q: Fill in each blank with the correct choice: When comparing two chromatographic methods, the better…

A: The resolution in a chromatographic method depends on two factors such as plate number and plate…

Q: A solution containing 2.30 mM of X (analyte) and 1.15 mM of S (standard) gave peak areas of 1728 and…

A: Given, known Amount of X = 2.30 mM, amount of S = 1.15 mM Peak area of X is 1728 and that of S is…

Q: A student analyzes sample 1, and sample 2 chromatograms of a mixture containing two compounds (A +…

A: The two samples( Compound A+Compound B ) are undergone chromatography : Compound A and Compound B

Q: Chromatography

Q: 4. The chromatogram below shows the separation of a mixture obtained by gas chromatography (GC)…

A: The principle of separation in gas chromatography (GC) is based on the partitioning of the sample…

Q: During Size exclusion chromatography, if VT = 30 mL, Vs = 15 cm3 , and VL = 15 mL, Vi is 7 mL…

A: Here VT = 30 mL, Vs = 15 cm3 , and VL = 15 mL,

Q: A chromatogram from a certain column has a peak with a w1/ 2 of 12 mm and a tr of 650 mm as…

A: Given, Width of half peak height , w12= 12 mm retention time , tr = 650 mm

Q: what is chromatography? Explain different types of chromatography and explain how to seperate…

A: Chromatography is a laboratory technique. It is use for the separation of the components or solutes…

Q: You are analyzing a forensic sample for the presence of controlled substances using HPLC. Which of…

A: Detector is given.

Q: For any chromatographic technique, tall and narrow peaks are preferred to short and broad peaks.

A: Given statement: For any chromatographic technique, tall and narrow peaks are preferred to short and…

Q: What is the relative retention of the two solute?

A: relative retention of the two solute

Q: A solution with 0.083 7 M X and 0.050 0 M S9 gave areas AX = 423 and AS9 = 372. Then 10.0 mL of 0.05…

A: Given: A solution having 0.0837 M X and 0.0500 M S’ showed peak areas AX = 423 and AS’ = 372,…

Q: A new dye (DYE C) was developed and was analyzed against other dyes using paper chromatography. A…

A: TLC is an analytical technique which can be used to monitor the organic reaction transformations.…

Q: Solvent Front Highest point of the dye Lowest point of the dye Rf Value Baseline Chromatogram A 15.0…

Q: None

A: Note that, Plate theory is a simplified model, and real chromatography behavior might deviate…

Q: Swer sections C, D and E in the same answer book. ction D (Chromatography) The following data were…

A: N = 1757.286 K' = 9.285 RS = 1.578

Q: If you spike the sample you collected with a known amount of the analyte of interest, you are…

A: The objective of the question is to identify the calibration method used when a known amount of the…

Q: A GC detector that ionizes each components of the sample and the mass is repeatedly scanned during…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A chromatogram gives an ideal Gaussian peak with tR = 9.40 min and win = 0.19 min. How many…

A: Chromatography is a techniques where separation of components takes places depending on various…

Q: Question 2 Retention time is the time spent by analyte in both mobile and stationary phases. True…

A: Kindly get the answer given below.

Q: calculate the following for each sample gas chromatograph. a) retention time for each peak (label…

A: The given plot is redrawn as shown below.

Q: How does the chromatogram change when methanol:water (90:10) is used as the mobile phase compared to…

A: Mobile phase is the fluid (liquid or gas) that usually flows through the chromatography system. It…

Q: A solution of HNO, is standardized by reaction with pure sodium carbonate. +2 Na* + H₂O + CO₂…

Q: 2. What are mobile and Stationary phases in a chromatogram? Site their nature.

A: The solution is given below -

Q: Analysis of an unknown plant extract yield two peaks X and Y in a chromatogram, 15.65 and 17.03 min…

Q: _is a technique which is used to separate a single chemical 3. compound from a mixture dissolved in…

A: Chromatography can be defined as the technique used for separating mixtures with the help of a…

Q: A chromatogram exhibited three peaks for the compounds A, B, and Cat 14.8, 15.5, and 16.2 minutes,…

A: Chromatography is a method by which a mixture is separated by distributing its components between…

Q: A student places an unknown sample on a thin-layer chromatography plate and develops it in…

A: The important points in the question are: An unknown sample was placed on a thin-layer…

Q: 5.) The literature value for the Ksp of lead(II) chromate is 2.8 x 10 13. Calculate the percent…

Q: All types of chromatography have mobile phaseand stationary phase. What is a stationary phase and a…

A: Stationary phase: It could be solid, or liquid supported on a solid layer or coating on the…

Q: Analysis of an unknown plant extract yield two peaks X and Y in a chromatogram, 15.65 and 17.03 min…

A: Two peaks X and Y in a chromatogram yields in 15.65 and 17.03 min respectively in a 30 cm column.…

Q: What is the stationary phase in thin layer chromatography and its polarity? Choices: Cellulose -…

A: In thin layer chromatography(TLC) silica is used as stationary phase. Silica is a polar adsorbent .

Q: The figure below shows a portion of a GC chromatogram for a mixture of two aromatic compounds…

A: To find out the time that components A and B spend in the stationary phase. The chromatogram given…

Q: would column chromatography separate ketone and alcohol

A: The detailed solution of the given question is solved below. COLUMN CHROMATOGRAPHY Column…

Q: 1. In thin layer chromatography (TLC), why do you need to use a pencil in marking the spots, origin,…

A: 1. Marker spot is soluble in the solvent. Therefore it will move on TLC plate with solvent. 2.…

Q: This is a developed paper Chromatogram. What is the Rf of the spot? You must use the given cm…

Question

4. On a 20 cm paper chromatography plate, an analyte was spotted 1 cm from the
bottom edge. The plate was developed until the solvent reached 1 cm from the
top edge. Measuring from the spot, the analyte traveled 2.88 cm. Calculate the Rf
of the analyte.
0.16
O 0.15
0.22
O 0.14

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Solution

VIEW

Step 2 solution

VIEW

Step 3 The answer

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

3 thank you !
Preparing a Thin Layer Chromatography experiment there are some common mistakes. Explain what happens in this situation: Sample spots too big
A standard sample contains 15.0 mM of analyte and 25.0 mM of internal standard. The analysis of the standard sample gives peak areas for the analyte and internal standard of 1.782 and 3.539, respectively, in a chromatography analysis. Then sufficient internal standard is added to a sample to make its concentration 10.0 mM. The analysis of this new sample yields peak areas for the analyte and internal standard of 0.894 and 2.981, respectively. Name the calibration method and report the analyte's concentration in the new sample. (e)
An analyst was measuring the performance of a HPLC column. The test solute was Toluene (5 µL). The column was a 4.6 mm i.d. column, 150 mm in length and packed with 5 µm C18 particles. The mobile phase was 40/60 water/methanol and the flow rate was 0.80 mL/min. The void time (to) was 1.86 minutes The retention time of the toluene sample was 14.50 min. The standard deviation of the peak was 7.0542 (s). 2a. The mobile phase velocity was? 0.0806 mm/s 0.1344 mm/s 1.344 mm/s 1.344 x 10³ mm/s (i) (ii) (iv) 2b. The number of theoretical plates was? (i) (ii) (iii) (iv) 2c. The height equivalent to a theoretical plate was? 1.041x10³ m 1.015x105 m 9.862x10-6 m 1.186x10¹² m (i) (ii) (iii) (iv) 4802 15210 24705 9848 2d. The reduced plate height was? (i) 2.03 (ii) 1.97 (iii) 7.55 (iv) 2.08 2e. The column was? (i) (ii) Extremely well packed Well packed Poorly packed (iii) (iv) Insufficient information to decide about the quality of the column
a. Separation of Peaks Below are two chromatograms after LC separation. Which chromatogram is better to proceed for MS analysis? What mobile phase condition/composition (LC separation) was used? HPLC: 15% H₂O, 85% CHCN, CIS Revane Phase, 100 mm long, 5pm particles (1) Area (1)-14750 Arta (2)-53538 MIN HPLC: 59% 10,49% CHCN, CIS Reverse Phase, 100 m long, 5 pm particles (2) Mes (1)-2256 A(2)-9536 A(3)-25638 13H
(6) Ms. Muna Al Naabi in the Analytical chemistry laboratory wanted to separate chlorophenol by liquid chromatography using C-18 column with 10 cm long. She has observed that a chromatogram with compound elute in 9.0 min with W½ = 2.0 min. Find the number of theoretical plate and plate height (in mm).
4. The paper chromatogram of an unknown mixture is shown below: final solvent level 5.3 ст 6.0 cm B 2.0 cm A 1.0 cm origin A. Using the measured distances find the retention factor of components A, B, and C. B. If the paper was run using hexane as the solvent, (a) which compound is the most polar? (b) the least polar? Explain your answer. C. What would you expect to happen to the Rf values if acetone was used instead of hexane as the solvent?
How do I answer this question?
Qno1: why there is a need of chromatography and chromatography thecniqs. B) when and where we should use normal and reverse phase chromatography
QUESTION 5 In a chromatographic separation using a polar stationary phase and a mobile phase composed of 60% hexane and 40% ethyl acetate, two compounds, benzene (peak A) and toluene (peak B), are eluted. The width of peak A at its base is 1.2 min, the width of peak B at its base is 1.3 min, and the retention time of peak A is 5.2 min and peak B is 3.5 min. What is the resolution (Rs) between these two peaks and is it acceptable? R = 1.36. It is not an acceptable resolution. R = 0.74. It is an acceptable resolution. R = 1.36. It is an acceptable resolution. R = 0.74. It is not an acceptable resolution.
A GC-MS was used to analyze an unknown sample. Based off the chromatogram, at least how many different compounds were in this sample? Detector Signal u M Retention Time
None