4. In a consolidated-drained triaxial test on a clay that is normally consolidated, the results are as follows: O3 = 15 lb/in 2 (Aoa)f = 11 lb/in? (Aua)f = 7.2 lb/in? a) Determine the consolidated-undrained friction angle. %3D b) Calculate the drained friction angle.

4. In a consolidated-drained triaxial test on a clay that is normally consolidated, the results are as follows: O3 = 15 lb/in 2 (Aoa)f = 11 lb/in? (Aua)f = 7.2 lb/in? a) Determine the consolidated-undrained friction angle. %3D b) Calculate the drained friction angle.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: data are given from the laboratory consolidation test. e₁ = 1.10 σ= 65.0 kN/m² e₂ = σ₂=240.0 kN/m²…

A: The Compression Index (Cc) is equal to the slope of the graph of pressure versus void ratio (log…

Q: Laboratory consolidation tests were conducted on a specimen collected from the middle of the clay…

A: The results of the field consolidation curve are interpolated from the laboratory test results.The…

Q: Question Attached

A: Principal Stress shows the maximum normal stress principal stresses are the maximum and minimum…

Q: A normally consolidated clay sample, which is fully saturated, was consolidated in the triaxial cell…

A: Given data- A normally consolidated clay sample. ½ (σ1 – σ3) = 1/3 σ3 and ½ (σ1′ + σ3′) = 2/3 σ'3…

Q: A clay stratum Sm thick has initial void ratio of 1.50 and effective overburden pressure of 120…

Q: A CU triaxial test was carried out on a silty clay that was isotopically consolidated using a cell…

Q: A tri-axial compression test on a cohesive sample cylindrical in shape yields the following…

A: We have to determine the value of cohesion of the soil as per the given data in the question like…

Q: on a normally consolidated clay are given next: Axial Strain, % Aa, kN/m2 Ud, kN/m2 0.5 156 99 0.75…

A: Sigma3=392 kN/m2

Q: sample of normally consolidated clay was subjected to a consolidated undrained triaxial compression…

A: Given, Pore pressure, U = 20kN/m²

Q: 2.9 A normally consolidated clay has the following values. Void ratio, e k (cm/sec) 0.2 x 10 0.91 X…

A: void ratio and permeability of a soil medium can be related to each other as follows…

Q: Determine a. Angle of friction, o' b. Angle 0 that the failure plane makes with the major principal…

Q: A triaxial test is performed on a normally consolidated clay. The sample is further consolidated by…

Q: A direct shear test, when conducted on a remolded sample of sand, gave the following observations at…

A: Given data For sand (C) = 0, Af = 36cm2 Normal load(N) = 288N Normal stressσf=28834=8 Ncm2 Shear…

Q: The following are the results of laboratory consolidation test conducted on clayey soil sample.…

A: The compression index is the slope of the virgin curve in the plot of void ratio versus the log of…

Q: The results of a consolidated undrained test, in which o3 = 392 kN/m², on a normally consolidated…

A: Given : Results of a consolidated undrained test on a normally consolidated clay σ3 =…

Q: ane shear test is used to determine the undrained shear strength of Ankara clay. If the clay is…

Q: a. Explain the Mohr's circles shown in Figure Q2 for a series of undrained tests and consolidated…

A: Mohr circle : A graphical representation of a general condition of stress at a spot is Mohr's…

Q: 1. The pressure versus void ratio data determined from a consolidation test on an undisturbed clay…

A: The pressure and void ratio are tabulated below.Pressure (kPa)Void…

Q: A Mohr stress circle of a triaxial test relevant to a general soil (c#0, #0) is seen in the Figure.…

A: Cell pressure = (20+a) KN/m2 a = 90 Cross sectional area (A) = 1.235 × 10-3 m2 at failure.…

Q: The height of the sample sand to be tested = 20 cm and the height of the saturated sand = 16 cm.…

A: Given data- height of sand sample h1=20 cmheight of saturated sand sample h2=16 cmTo Find-The…

Q: Calculate the consolidated-undrained friction angle and the drained friction angle.

A: Consolidated undrained test

Q: The results of two drained triaxial tests on a saturated clay are given next: Specimen I: Chamber…

Q: Instruction

Q: The following data are given for normally consolidated clay: Thickness=2.6m Primary Cc=0.3…

Q: A consolidated-undrained test on a normally consolidate clay yield the following results: Confining…

A: For normally consolidated clay…

Q: Q3) A normally consolidated clay has the following values: Estimate the magnitude of k of the clay…

A: It is the ability of the soil to allow water to pass through the void space of the soil. The clay…

Q: indicate the final answer in 3 decimal places.

A: To Determine The consolidated undrained friction angle (Φ)

Q: Oz = 276 kN/m? (Aoa)f = 276 kN/m?

Q: In general, clays tend to have a more pronounced failure: -True -False

A: Solution solution of above question is in second step

Q: A consolidated-undrained test on a normally consolidate clay yield the following results: Confining…

Q: 8.2 The results of a laboratory consolidation test on a clay sample are given below. Pressure, o…

A: Given:- The results of a laboratory consolidation test on a clay sample are given below.

Q: A consolidated undrained test on a saturated sand yielded the following results. 03 = 12 Ib/in?…

Concept explainers

Braced cuts

The braced cut is a method of providing lateral support to the soil in foundation trenches, to prevent the trenches from deformation by the caving in of soil and resisting it from moving laterally. During shallow excavation in firm soil, generally, slopes are provided to resist the caving in of soil. During shallow excavation in soft soil and deep excavation, the chances of caving in of soil increase. Hence, it becomes necessary to make a provision to resist the deformation of trenches due to caving in of soil. The braced cut is the method used for such conditions. The excavation using braced cuts is a bit uneconomical as compared to the traditional open-cut excavation method but provides better safety than the cut excavation method.

Question

4. In a consolidated-drained triaxial test on a clay that is normally consolidated, the results are
as follows: O3 = 15 lb/in
2
(Aoa)f = 11 lb/in?
(Aua)f = 7.2 lb/in?
a) Determine the consolidated-undrained friction angle.
%3D
b) Calculate the drained friction angle.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A consolidated-drained triaxial test was conducted on a normally consolidated clay. The results are as follows: • 03 = 16 lb/in. • (Aoa) = 25 lb/in. Determine a. Angle of friction, d'
Data from an oedometer test using a clay specimen are plotted in the graph shown below. If the compression index is equal to 0.6, calculate the void ratio (e2) missing at Point C, which is associated with a vertical effective stress equal to 105 kPa
Help me answer pls
Solve correctly otherwise skip it
2. The results of a consolidated-drained triaxial test conducted on a normally consolidated clay are as follows: Chamber confining stress = 220 KPa Deviator stress at failure = 320 KPa (a) Angle of friction (b) Angle of failure (c) Normal and Shear stress on the failure plane Calculate:
7.14 For a normally consolidated clay, the following values are given: Void ratio, e k (cm/sec) 0.95 0.2 x 10-6 0.91 x 10-6 1.6 Estimate k at a void ratio of 1.1. Use Eq. (7.38). Ⓒ Cengage Learning 2014
Q: A consolidated-drained tri-axial test was conducted on a normally consolidated clay. The results are as following: confining stress, G3 = 150 kN/m² and deviator stress, (Aod)t = 150 kN/m². i) Determine angle of friction, q; ii) Determine angle 0 that the failure plane makes with the major principal plane; iii) Find the normal stress and the shear stress ty on the failure plane; and iv) Determine the effective normal stress on the plane of maximum shear stress. Express your results in two decimal places.
The coefficient of earth pressure at rest for a sand having the Poisson's ratio value of 0.25 is. ?
Prob- The various approximations approaches described in this section can be used to compare K_a for both a normally consolidated (nc) clay and a clay with a known value of OCR = 5.0.
Triaxial compression test (CU) is conducted on a normally consolidated clay at a confining pressure of 100 kPa. The deviator stress at failure is 80 kPa, and the pore-water pressure measured at failure is 50 kPa. Determine the angle of internal friction.
A consolidated-drained triaxial test was conducted on an overconsolidated clay sample. The sample failed in test 1 at 01=200 kPa and 03=130 kPa, and in test 2 at o1=400 kPa and 03=290 kPa. Determine the undrained and drained friction angles and cohesion for the assumption that the Skempton's pore water pressure parameter A=0.45. Also, for a CU test on the same soil, determine o1, 1', 03', and excess pore water pressure u for 03=340 kPa.
anwer in complete solution