1. The pressure versus void ratio data determined from a consolidation test on an undisturbed clay specimen are as follows: Applied Pressure (kPa) 20 40 80 160 320 640 1280 320 80 20 0 Void Ratio 0.953 0.948 0.938 0.920 0.878 0.789 0.691 0.719 0.754 0.791 0.890 (a) Plot this pressure versus void ratio data on a semi-logarithmic graph. (b) Determine the equations for the virgin compression curve and for the rebound curve for unloading starting at 1,280 kPa. (c) What are the corresponding compression and recompression indices for this soil? (d) Estimate the stress to which this clay has been preconsolidated. (After A. Casagrande.)

1. The pressure versus void ratio data determined from a consolidation test on an undisturbed clay specimen are as follows: Applied Pressure (kPa) 20 40 80 160 320 640 1280 320 80 20 0 Void Ratio 0.953 0.948 0.938 0.920 0.878 0.789 0.691 0.719 0.754 0.791 0.890 (a) Plot this pressure versus void ratio data on a semi-logarithmic graph. (b) Determine the equations for the virgin compression curve and for the rebound curve for unloading starting at 1,280 kPa. (c) What are the corresponding compression and recompression indices for this soil? (d) Estimate the stress to which this clay has been preconsolidated. (After A. Casagrande.)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

5. A consolidated, undrained triaxial test is being carried out on a normally consolidated clay where c - 0 and p'= 26'. The triaxial specimen was consolidated under a cell pressure of 300 kPa and backpressure of 80 kPa. Skempton's A parameter at failure is estimated to be 0.80. The drainage valve has since been dosed and the vertical deviator stress increased to failure. What would be the deviator stress and pore water pressure at failure?
A consolidated tri-axial test was conducted on a normally consolidated clay. The results were as follows: Chamber confining pressure = 346 kPa, Deviator stress = 403 kPa. Compute for the shear stress on the failure plane in kPa. Round off to two decimal places.
Find the C, and the "apparent" OCR for a superficial clay stratum that is 4m thick. The water is at the surface. A sample of the clay has a water content of 27.9%, and a specific gravity of 2.65. An oedometer test showed the following results: Voids Ratio 0.736 0.733 0.73 0.675 0.638 0.6 Vertical Effective Stress 15 28 60 230 480 930
A clean sandstone core sample with diameter of 3.8 cm and length of 5.6 cm is saturated with a brine. The core was desaturated in several steps, and the resistance was measured at each saturation. The results are as follows: Water Saturation (Fraction) Resistance (kS) 1.000 1.302 0.900 1.695 0.800 2.283 0.730 2.878 0.640 3.775 0.560 5.637 0.480 7.838 0.375 13.175 0.350 17.050 0.300 26 Brine resistivity= 0.74 2m Archie coefficient 1.03 Cementation factor= 2.2147 (1) Estimate the rock porosity. (2) Determine the saturation exponent. (3) Estimate the amount of oil and brine (in cc) in the core sample when resistivity index is 5. All steps of the calculations should be shown.
A sample of moist sand was subjected to a series of triaxial tests. The soil fails under the following stresses Cell pressure, σ3 Plunger stress, σd Sample 1 11 kPa 20 kPa Sample 2 26 kPa 31 kPa What is the angle of internal friction and cohesion of the soil? Please answer this asap. For upvote. Thank you very much
Solve correctly otherwise skip it
a. A shear box test carried out on a soil sample gave the following results ✓ Vertical load [kg] 36.8 73.6 110.4 147.2 Gauge reading for proving 16 26 35 44 (shearing) ring [μm] If the shear box is 60 mm square and the proving ring constant/factor is 20 N/μm, determine the apparent cohesion and angle of internal friction for this soil. HINT: Determine normal stress from vertical load readings and shear stress from proving ring readings
A consolidated-undrained test was conducted on a normally consolidated clay sample. The results are as follows: Undrained angle of friction = 38.65°, Drained angle of friction = 62.59°, Deviator stress at failure = 509 lb/ft^2. Determine the pore water stress at failure in lb/ft^2.
A CID TXC test was performed on a sample of sand. At the end of consolidation, the back pressure was 140 kPa, and the cell pressure was 340 kPa. At failure, the deviator stress was (ơ1 – 03)f = 200 kPa. a. What was the total pore water pressure, u, at failure? b. Calculate the principle effective stresses, ơi' and os', at failure. c. Calculate the friction angle, d', for this soil.
Q # 1. Organic soils are typically characterized by high void ratio, low specific gravity, and high compressibility. Following are the results of a consolidation test on a sample of organic soil. Pressure, o (kN/m2) Change in dial reading, AH (mm) 0.284 12 0.150 24 0.315 48 0.564 100 0.823 200 2.25 400 5.34 Given that the initial height of the specimen = 20.6 mm, mass of dry specimen = 12 g, area of specimen = 31.67 cm2 and G, = 2.49. Plot the e, log o' curve. b. Determine the preconsolidation pressure. a.
Note) For soil sample in Table 2, initial thickness of sample = 14.31 mm, sample area = 2827.433 mm^2, dry weight measured at the end of test = 52.53 g, specific gravity = 2.7 Also, Determine the compression index and expansion index Please show graph