•4-69. Three bars each made of different materials are connected together and placed between two walls when the temperature is T, = 12°C. Determine the force exerted on the (rigid) supports when the temperature becomes T = 18°C. The material properties and cross-sectional area of each bar are given in the figure.

Q: The 2.5-kg collar is at rest in position A when the constant force P is applied as shown. Determine…

A:

Q: (1) A B

A: for solution refer below images.

Q: Cable AD in (Figure 1) is tightened by a turnbuckle and develops a tension of 1500 lb.. Figure 300…

A:

Q: The rigid bar AOB is pinned at O and connected to aluminum and steel rods. If the bar is horizontal…

A:

Q: At a temperature of 11°C, a 2-mm gap exists between two polymer bars and a rigid support, as shown…

A:

Q: The 58-mm-diameter cylinder is made from Am 1004- T61 magnesium and is placed in the clamp when the…

A:

Q: The deck of a bridge is made up of 12 mm thick steel plates 2 m long by 1·2 m wide. Under load, the…

A:

Q: Determine the force in the rod AB caused by the increase in temperature. Express your answer to…

A:

Q: The central bar CD of the assembly is heated from 30 ° C to 180 ° C by means of an electrical…

A:

Q: A rod made of 2014-T6 aluminum fits securely between its fixed supports A and B when the temperature…

A:

Q: Please solve the problem in a sheet of the paper and draw the free body diagram.

A:

Q: 10 kN B 6 m 3 m 3 m A D 60 kN

A:

Q: A girder shown in the following figure is supported by two cables. The weight of the girder is 8000…

A: For the given girder  Weight of girder (W) = 8000 lb    To determine  The tension in both cable and…

Q: The system is made of 2 separate rods (cross-section is a circular). The blue rod is made from…

A:

Q: A rod made of 2014-T6 aluminum fits securely between its fixed supports A and B when the temperature…

A: The thermal stress in the rod due to temperature difference in the rod can be calculated using the…

Q: The 58-mm-diameter cylinder is made from Am 1004-T61 magnesium and is placed in the clamp when the…

A:

Q: B -1.5 m Figure 2 The -red-brass rod AB of 1.5 m and the aluminium rod BC of 1 m, shown in Figure 1,…

A:

Q: The lower ends of the three steel bars in Figure are at the same level before the applied…

A:

Q: If the temperature of the 85 mmmm diameter post CD is increased by 60 ⚫C, determine the force…

A:

Q: The collar C is fixed to rod AB using a glued bond that allows a maximum force of 405 N parallel to…

A: Given Data: The maximum force allowed is:Fmax=405 N Now from the figure write the position of…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.