A girder shown in the following figure is supported by two cables. The weight of the girder is 8000 lb. Determine the unknown angle α and the tension in both cables

Q: Suppose that P₁ = 600 lb and P₂ = 800 lb. Suggestion: Use the sections shown in (Figure 1). Figure 6…

A:

Q: Two flowerpots are supported with cables as shown in the figure. If pot A weighs 16 lb and mot B…

A: Given data  Weight of A = 16 lb Weight of B = 9 lb Find the tension in each cable and angle alpha.

Q: 1) The cantilever truss is loaded with P as shown in the figure. The load P is 19.99kN. Determine…

A: P=19.99 kNL=7.2 mH=2.6 md=1.6 mTo determine forces in member KL and CL.

Q: b) For the truss structure in Figure Q4, determine the forces FAE, FAB and FCF acting in members AE,…

A:

Q: a=(3.7m) , b=(3.7m) ,theta =(33) , p1=(3.7)KN , p2=(2.4)KN     find the forces in each members…

A: According to the given dataWe need to findforce in each member.

Q: A Pratt truss supports three forces at joints along the bottom edge, as shown in the figure below.…

A:

Q: A bent pipe is attached to a wall with brackets as shown. A force of F = 105 lb is applied to the…

A:

Q: A bent pipe is attached to a wall with brackets as shown. A force of F = 170 lb is applied to the…

A: Given data, Force, F = 170 lb a = 8.68 in b = 14.9 in c = 14.2 in d = 46.5 in h = 29.5 in g = 31 in…

Q: A wire is stretched tight between two pylons, one of which is shown in Fig. to the xy-plane and…

A: Draw the free-body diagram for joint D.

Q: A 30° 20 kN B 10° G. F E D 20 kN 20 kN Y 20 kN 2 m 2 m -2 m

A:

Q: A stepped bar is held in equilibrium by several forces acting at different points along the length,…

A:

Q: The simplest truss consists of two rods and is loaded by the force F. Given: F = 7 kN. Angle α = 50…

A:

Q: Determine the support reactions of the frame shown in the following figure. Also, determine internal…

A: According to the given data  we need to find Support reaction Internal forces at point C

Q: segment CB, as shown in the figure. The bar is supported by a pin at point B and a cable CD is…

A:

Q: Determine the components of reaction at the ball-and-socket joint AA using scalar notation.…

A:

Q: B D 4 m 5m H 5 m 5 m 5 m A G F 30 kN 60 kN 30 kN

A: Structure is the  member which is used to transfer the forces and to withstand with loads. A truss…

Q: An inclined truss supports three forces at joints along the left edge, as shown in the figure below.…

A:

Q: Odd side please

A:

Q: Determine the tension in the rope at point A and the reactions at the pin support at point B. (The…

A:

Q: A frame structure, as shown in the following diagram, is given. Calculate: (a) Reaction forces at…

A:

Q: Question 1: 3 m Find the x and z components of the support reaction at the journal bearing at A and…

A:

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.