3 m 10 kN/m 3 m 30° Problem 2 Fig 2 A beam subjected to distributed load in the manner shown in Fig. 2 is supported by a pin at end C and stabilized with cable AB hanging over a frictionless pulley. (a) Replace the distributed loading by an equivalent resultant force, and specify its location on the beam, measured from the pin at C. (b) Draw the free body diagram the cable and determine the reaction forces at pin C and the tension in

3 m 10 kN/m 3 m 30° Problem 2 Fig 2 A beam subjected to distributed load in the manner shown in Fig. 2 is supported by a pin at end C and stabilized with cable AB hanging over a frictionless pulley. (a) Replace the distributed loading by an equivalent resultant force, and specify its location on the beam, measured from the pin at C. (b) Draw the free body diagram the cable and determine the reaction forces at pin C and the tension in

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter9: Application Of Influence Lines

Section: Chapter Questions

Problem 11P

See similar textbooks

Similar questions

A beam is part of the framing system for the floor of an office building. The floor is subjected to both dead loads and live loads. The maximum moment caused by the service dead load is 45 ft-kips, and the maximum moment for the service live load is 63 ft-kips (these moments occur at the same location on the beam and can therefore be combined). a. If load and resistance factor design is used, determine the maximum factored bending moment (required moment strength). What is the controlling AISC load combination? b. What is the required nominal moment strength for a resistance factor of 0.90? c. If allowable strength design is used, determine the required moment strength. What is the controlling AISC lead combination? d. What is the required nominal moment strength for a safety factor of 1.67?
For the beam shown: (a) determine the distance a for which the maximum positive and negative bending moments in the beam are equal; and (b) draw the corresponding shear and bending moment diagrams for the beam.
Verify the value of Zx for a W1850 that is tabulated in the dimensions and properties tables in Part 1 of the Manual.
Describe how an electrician can tell Type AC and Type MC cable apart. (Objective 2-5)