Direction: Write the answer in a bond paper with complete solutions drawings. Strictly write in bond paper and picture it. Topic: Sheer & Moment diagrams, Reaction at Supports, Load Tracing, Method of Joint, and Method of Section Course: Theory Of Structure 6. METHOD OF JOINT3-9. Determine the force in each member of the truss.State if the members are in tension or compression.9 ft2kEBC30°12 ft12 ft12 ftProb. 3-9 5.3-3. Classify each of the following trusses as staticallydeterminate, indeterminate, or unstable. If indeterminate,state its degree.(a)(b)(c)

6. METHOD OF JOINT 3-9. Determine the force in each member of the truss. State if the members are in tension or compression. 9 ft 2k E B C 30° 12 ft 12 ft 12 ft Prob. 3-9 5. 3-3. Classify each of the following trusses as statically determinate, indeterminate, or unstable. If indeterminate, state its degree. (a) (b) (c)

6. METHOD OF JOINT 3-9. Determine the force in each member of the truss. State if the members are in tension or compression. 9 ft 2k E B C 30° 12 ft 12 ft 12 ft Prob. 3-9 5. 3-3. Classify each of the following trusses as statically determinate, indeterminate, or unstable. If indeterminate, state its degree. (a) (b) (c)

Steel Design (Activate Learning with these NEW titles from Engineering!)

6th Edition

ISBN:9781337094740

Author:Segui, William T.

Publisher:Segui, William T.

Chapter10: Plate Girders

Section: Chapter Questions

Problem 10.7.9P

See similar textbooks

Similar questions

A beam is part of the framing system for the floor of an office building. The floor is subjected to both dead loads and live loads. The maximum moment caused by the service dead load is 45 ft-kips, and the maximum moment for the service live load is 63 ft-kips (these moments occur at the same location on the beam and can therefore be combined). a. If load and resistance factor design is used, determine the maximum factored bending moment (required moment strength). What is the controlling AISC load combination? b. What is the required nominal moment strength for a resistance factor of 0.90? c. If allowable strength design is used, determine the required moment strength. What is the controlling AISC lead combination? d. What is the required nominal moment strength for a safety factor of 1.67?
For the beam shown: (a) determine the distance a for which the maximum positive and negative bending moments in the beam are equal; and (b) draw the corresponding shear and bending moment diagrams for the beam.
Verify the value of Zx for a W1850 that is tabulated in the dimensions and properties tables in Part 1 of the Manual.
Compute the nominal shear strength of an M107.5 of A572 Grad 65 steel.