28 kips 28 kips 12 in. 1.5 in. - 2.25 in. 18 in. E

Q: The rectangular bar has a width of w = 3.00 in. and a thickness of t = 2.00 in. The normal stress on…

A: (a) The magnitude of load P is 59.04 kips. (b) The shear stress on plane AB is 4.8 ksi. (c) The…

Q: The rectangular bar has a width of w = 3.50 in. and a thickness of t = 1.50 in. The normal stress on…

A:

Q: (4) The shown cast-iron bracket has an ultimate compressive strength of 504 MPa and an ultimate…

A: The ultimate compressive strength is σc=504 MPa. The ultimate tensile strength is σt=225 MPa The…

Q: The rigid wrench (not the brand Rigid sold at Home Depot!) shown is used to loosen a stuck nut at…

A:

Q: The lap joint is fastened by 5 one-inch diameter rivets. For P = 10 kips, determine (1.) the maximum…

A: Givenn=5d=1inP=10kipst1=34int2=58inw=4in

Q: A pulley is supported by a circular pin at A. The pin has a diameter of d = 0.375 in., and each side…

A:

Q: The rigid beam BC is supported by rods (1) and (2). The cross-sectional area of rod (1) is 9 mm².…

A: Given: The cross sectional area of rod 1A1=9 mm2=9×10-6m2 The cross sectional area of rod 2A2=18…

Q: The rigid bar ABD is connected to the rod BD which consists of a single bar with a width of 25,0 mm…

A:

Q: Two solid cylindrical rods (1) and (2) are joined together at flange B and loaded as shown. If F₁ =…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.