Two solid cylindrical rods (1) and (2) are joined together at flange B and loaded as shown. If F₁ = 13 kips, F2 = 34 kips, and the normal stress in each rod must be limited to 22 ksi, determine the minimum diameter d₁ required for rod (1).

Q: Q2/ Segments AB and BC of the assembly below are made from 6061-T6 aluminum. If a couple forces P= 5…

A: ∑Mx=0Ta+Tc-3X5=0                           (1) COMPATABILITY,…

Q: (a) If the rope is subjected to a vertical force of P = 500 N, determine the normal stress at points…

A: Diameter of the wooden post - 40 mm = 0.04 mVertical force, P =500 N

Q: o solid cylindrical rod= C are welded together d as shown. The force Determine the average at the…

A:

Q: 2.17 In using this leg curl machine the exertion of the legs results in a torque M 120 lb-ft on the…

A:

Q: 2. Determine the maximum force P that can be exerted on each of the two pistons so that the…

A: Given: The radius of the piston is R=45 mm. The wall thickness is t=2 mm. The circumferential stress…

Q: The rectangular bar has a width of w = 3.50 in. and a thickness of t = 1.50 in. The normal stress on…

A:

Q: The rigid wrench (not the brand Rigid sold at Home Depot!) shown is used to loosen a stuck nut at…

A:

Q: Rod BD is made of steel (E= 29 × 100 psi) and is used to brace the axially compressed member ABC.…

A:

Q: The smallest allowable length L of the bearing plate is in.

A: Given data

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.