2. The following sketch shows the results of a paper chromatography experiment. At the beginning, pure substances A, B, and C were spotted at the points labeled as "x" marks. The dotted line shows the solvent front. The Rf values of A, B, and C are respectively 0.25, 0.75, and 0.50. Where would you expect the spots for the three substances to be when the experiment is completed? Sketch rough circles. 100 80 60 40 20 B

2. The following sketch shows the results of a paper chromatography experiment. At the beginning, pure substances A, B, and C were spotted at the points labeled as "x" marks. The dotted line shows the solvent front. The Rf values of A, B, and C are respectively 0.25, 0.75, and 0.50. Where would you expect the spots for the three substances to be when the experiment is completed? Sketch rough circles. 100 80 60 40 20 B

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A gas chromatogram of a mixture of toluene and ethyl (a) Measure w1/2 for each peak to the nearest 0.1 mm. When the thickness of the pen trace is significant relative to the length being measured, it is important to take the pen width into account. It is best to measure from the edge of one trace to the corresponding edge of the other trace, as shown at the bottom of the left column. (b) Find the number of theoretical plates and the plate height for each peak.
For what type of separation would you use ion exchange chromatography (IC)?
Answer the following questions.
Question 7 TLC is an example of liquid-liquid partition chromatography. A True B) False
4. a. What physical property of a compound predicts whether that compound travels slowly or rapidly through a Gas Chromatograph? b. Suppose you injected a sample of 25% compound A. (bp 80 °C), 5% compound B (bp. 40°C) and 70% Compound C (bp 60 °C) on a GC. inject Circle the Chromatogram that actually fits that scenario and cross the other one out. On the correct GC, label the peaks on the chromatogram with the compounds A, B, and C. inject
Next, 2.00 mL of 9.63 mM S was added to 10.00 mL of a solution of unknown concentration of X, and the mixture was diluted to 25.0mL. Chromatographic analysis of this solution produced peak areas of 4822 for X and 4099 for S. What was the concentration of 5 (in mM) of the 25.0mL solution?
You were analyzing a mixture of volatile solvents using Gas Chromatography and found out that two peaks are unresolved (not well-separated) using your initial program. Which method can you use to obtain a chromatogram with well separated peaks?
When the soft drink Jolt is used in place of Coke in the HPLC experiment, the concentration of caffeine in the injected sample is found to be 5.9 x 10- M. What peak area corresponds to this concentration? Explain how you came up with your answer.
You run the chromatography system with paper as the stationary phase and 70% isopropanol as the mobile phase. You determine the Rf of a polar analyte to be 0.40. If you use 100% isopropanol (a less polar solvent) instead of isopropanol as the mobile phase what would you expect to happen to the Rf value? No value effect on Rf higher lower could be higher or lower
2
What kind of mixtures are separated by gas-solid chromatography?
3. A student administered ibuprofen to a lab mice orally. She would like to find out the amount of ibuprofen in blood plasma at a specific time using HPLC. The chromatographic peak areas after 2 hours, 4 hours, and 8 hours are 38.34, 20.5, and 14.95 respectively. What is the concentration of ibuprofen in the plasma at each aforementioned time? Below is the corresponding peak area of the 5 ibuprofen standards. Standard Concentration (mg/mL) Peak area 5.02 0.5 1.0 10.05 2.0 17.15 3.0 19.79 6.0 39.72