2. A machine operator produces the tension Tin the control rod by applying the force Pto the foot pedal. Determine the largest P if the magnitude of the pin reaction at B is limited to 1.8 kN. Neglect the mass of the mechanism. wwwww 50 B 25° 150 50 T Dimensions in mm

Q: If the cart's mass is 32 kg and it is subjected to a horizontal force of P-90 N. determine the…

A:

Q: has a mass of 75 kg. 6-90 The plate shown in Fig. The brackets at supports A and B exert only force…

A: Write the position vector of the points A, B, C and D.

Q: Determine the magnitude of the vertical reaction force at D. Assume a = 4.9 ft, b = 9.8 ft, c = 19.6…

A:

Q: The horizontal steel shaft has a mass of 590 kg and is suspended by a vertical cable from A and by a…

A: Given Data m=590 kg

Q: Evaluate the force in member CF and mention if it is in compression or tension A 3 m B 3 m 45° 23 m…

A: Evaluate the force in the member CF and mention if it is in compression or tension.

Q: Determine the horizontal and vertical components of force which the pin at C exerts on member BC of…

A:

Q: The mass center Gof the 1400-kg rear-engine car is located as shown in the figure. Determine the…

A:

Q: The wall-mounted 3kg light fixture has its mass centre at G. Determine the vector reactions at A.…

A:

Q: 30° T₁ T₂ Ţ₁ FOLE T₁ То m 10 T3 O F m T₁ ¹6

A: For the solution refer below images.

Q: Determine the horizontal and vertical components of force which the pin at C exerts on member BC of…

A:

Q: Machines: The mechanical press is used to crush small objects at E. If the vertical force P = 750 N…

A:

Q: 2. The 30 cm handle is connected rigidly to the 5cm bar at a right angle. Determine the force…

A: The force applied to the handle is, P=100 N Length of the handle is, L=30 cm

Q: Consider the following system in static equilibrium. Force vector Facts at a distance" from the pin…

A: (a) Draw the free-body diagram of bar.

Q: 600 lb C 18 25 750 lb-ft B 10 900 lb| Dimensions in inches

A:

Q: Solution: FA 147.15 N, FB = 254.87 N = 60° 30 kg B 30°

A: Given:The mass of the barrel,

Q: 1- Determine the angle 8 for equilibrium and investigate the stability of the mechanism in this…

A: given :spring is unstretched,when mass of block A= m= 40 kgspring stiffness= k= 1.5 kN/m

Q: The uniform 16-kg plate is welded to the vertical shaft, which is supported by bearings A and B.…

A:

Q: 4. A 45-kg street sign is being held in place by three wires and a ball/socket joint. Determine the…

A: The mass of street sign is

Clutches, Brakes, Couplings, and Flywheels

The clutch is described as a machine element used to connect or disconnect two shafts together to transmit torque or power. The clutch works on the principles of friction. The clutch is commonly used in automobiles to transfer power from the driving shaft to the driven shaft.