13.9 Determine the shape factor, F12, for the rectanglesshown.6 m13 m6 m1 m26 m10.5 m21 m(a) Perpendicular rectangleswithout a common edge.-1 m.(b) Parallel rectangles ofunequal areas.

Answered: 13.9 Determine the shape factor, F12,…

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter9: Moments And Products Of Inertia Of Areas

Section: Chapter Questions

Problem 9.24P: Determine Ix for the triangular region shown.

See similar textbooks

Similar questions

* .Find (ly) for the shaded area Y 2m 2 6m 1 03 3m 3m 3m 3.
Find Ix and Iy for the L-shaped cross-section shown.
How would i find the area of both cells in this circle?
Determine Ix for the triangular region shown.
Use integration to verify the formula given in Table 9.2 for Ixy of a half parabolic complement.
Ty
3 29knd. A cylinder of 50 mm diameter and height 60 mm is resting on base in H.P. A circular hole of 20 mm diameter is drilled , so that the axis of the hole is perpendicular to V.P and bisects the axis of cylinder at right angles . Draw the development of the lateral surface of the cylinder with the slot . Draw neatly with pencil and take correct values must**
There are no numbers that answer should be symbolic. There should be 2 coordinates that are symbolic.
A stainless steel woven wire screen with a square aperture had an aperture 3.18 mm. The diameter of the wire was 1.2 mm. Determine 1. The percent open area when the screen was operated in a horizontal position 2. The percent open area when the screen was operated at the slope of 20" 3. The mesh size of the screen
A hexagonal plane of side 30mm has a corner on the ground. Its surface is inclined at 45 degree to the HP and perpendicular to the VP . Draw its projections when the diagonal through the corner in the HP is parallel to the VP.
300 270 240 210 Gap: 2" Width: 0.125" 180 Thickness: 0.125" 150 120 90 60 30 POSITION, In .050 .100 .150 .200 .250 .300 350 400 450 .500
Compute the coordinates of the centroid (,) of the area shown. Also compute the area moment of intertia about the x' and y' axes with origin at the centroid. ур C + 2013 Michael Swanbom cc 10 BY NC SA a*b* - a a → x Values for dimensions on the figure are given in the following table. Note the figure may not be to scale. Variable Value a 41 cm b 25 cm с 50 cm The x coordinate of the centroid is = cm. The y coordinate of the centroid is y cm. The moment of inertia about the x' axis going through the centroid is I' The moment of inertia about the y' axis going through the centroid is I✓ cm4. cm4.

SEE MORE QUESTIONS

Recommended textbooks for you

International Edition---engineering Mechanics: St…

Mechanical Engineering

ISBN:

9781305501607

Author:

Andrew Pytel And Jaan Kiusalaas

Publisher:

CENGAGE L