1.0 g of a compound A is prepared in 100 mL of water, and then extracted with 50 mL of ether. After the extraction, 0.25 g of the compound was recovered from the ether layer. What is the partitioning coefficient([A]ether/[A]water) for this compound in the system used? 50 ml ether 0g 0.25 g 1g 100 ml water O 4.0 O 3.0 O 1.5 O 0.75 O 0.25 O 0.67

1.0 g of a compound A is prepared in 100 mL of water, and then extracted with 50 mL of ether. After the extraction, 0.25 g of the compound was recovered from the ether layer. What is the partitioning coefficient([A]ether/[A]water) for this compound in the system used? 50 ml ether 0g 0.25 g 1g 100 ml water O 4.0 O 3.0 O 1.5 O 0.75 O 0.25 O 0.67

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Find the chemical shift of C7H7Cl (4-Chlorotoluene) in ppm 4-Chlorotoluene is a ring structure with a chlorine group and a methyl group. Please help me understand the chemical shift of the hydrogens.
6
PLEASE ANSWER ASAP
For an analysis of phthalates by GC-MS, the limits of detection and quantitation are 0.55 and 3.56 mg/g, respectively. Based on the results obtained below, how are the 3 samples reported? Sample Concentration (mg/g) A 4.50 B 0.055 C 0.56
River water analysis of mercury (Hg) yields a spectrophotometric sample signal of 0.712 for a 5.00 mL sample. A 5.OuL spike of 1560 ppb Hg standard produced a signal of 1546. What is the concentration of Hg in the original river water sample? What is the concentration of Hg in the original river water sample? A. 1.109 ppb B. 1.330 ppb C. 1.771 ppb D. 1.546 ppb
3 to the kit manual 200uL of plasma was mixed with 2.8 ml of the dilution buffer, mixed well then 200 uL of the dilution mixture was pipetted in 0.9 ml of solution A and 0.9 mL of solution B and measured using a spectrophotometer, the concentration was 30. What is the final concentration of the sample after adjusting the dilution factor
None
What is the relationship between chemical shift in ppm and operating frequency?
What is the molar extinction coefficient at 625 nm for this copper (II) acetate solution? How was it determined? Standard Solution Concentration (M) Absorbance 1 0.025 0.049 2 0.050 0.153 3 0.100 0.242 4 0.200 0.499 5 0.250 0.694
A compound Y is to be determined by UV-visible spectrophotometry. A calibration curve is constructed from standard solutions of Y with the following results: 0.20 ppm, A = 0.870; 0.40 ppm, A = 0.840; 0.60 ppm, A = 0.800; 0.80 ppm, A = 0.750; 1.00 ppm, A = 0.700; 1.50 ppm, A = 0.620; and 2.00 ppm, A = 0.530. a. What is the equation of the calibration curve for compound Y? b. What is the linearity of the calibration curve for compound Y?
6. The UV-Vis absorption spectrum was measured for three different concentrations (10 mM, 20 mM, and 30 mM) of an analyte that we will call orangium as shown in the figure below. A 1.000 cm cuvette is used for all of the experiments. 1.00 0.90 0.80 0.70 0.60 a 0.50
5