1. Reaction rate data of an enzyme, E, and a substrate, S, with increasing inhibitor concentrations are listed in the table below (Cs and C₁ represents the concentrations of the substrate and the inhibitor, respectively). Reaction Rates (μmol.Li¹.s¹) [CS] (mmol/L) [CI]=0 [CI]=0.25 [CI]=0.50 mmol/L mmol/L mmol/L 0.10 0.79 0.57 0.45 0.15 1.11 0.84 0.66 0.20 1.45 1.06 0.86 0.30 2.00 1.52 1.22 (a) Calculate Vmax (mmol.m³.s-¹). (b) Calculate Kм (g.mol.m³). (c) Describe the type of this inhibition.

1. Reaction rate data of an enzyme, E, and a substrate, S, with increasing inhibitor concentrations are listed in the table below (Cs and C₁ represents the concentrations of the substrate and the inhibitor, respectively). Reaction Rates (μmol.Li¹.s¹) [CS] (mmol/L) [CI]=0 [CI]=0.25 [CI]=0.50 mmol/L mmol/L mmol/L 0.10 0.79 0.57 0.45 0.15 1.11 0.84 0.66 0.20 1.45 1.06 0.86 0.30 2.00 1.52 1.22 (a) Calculate Vmax (mmol.m³.s-¹). (b) Calculate Kм (g.mol.m³). (c) Describe the type of this inhibition.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

The enzyme examase catalyses the following reaction, A - B where A is the reactant and B is the product A595 measurements were used to determine the catalytic activity of examase by measuring the rate at which B is produced. From this, the activity of the enzyme was determined to be 42 µmol/mL per minute. A standard albumin solution (concentration = 10 mg/mL) was used to prepare a standard curve of Abs595 vs amount of protein in mg. The protein assay was also performed using 100 uL of a 1 in 10 dilution of the original examase sample. For the absorbance measurements, it was determined that the sample used in the A595 measurement contains 1.2 mg of examase. Which of the following statements correctly gives the specific activity of examase? 1.0.35 U/mg O 2.0.035 U/mg 3. 5040 U/mg O 4.35 U/mg O 5.3.5 U/mg
Question 33
Using this graph, what can be determined about the effect of enzyme concentration on the initial rate of the reaction and on the amount of product formed?
Use the reaction energy diagram above to answer the following questions.
In order to describe the reaction sequence of two different substrates catalyzed by an enzyme; E + S1 ↔ ES1ES1 + S2 ↔ ES1S2ES1S2 → P + E a.Derive the rate equation for the reaction with the Michaelis-Menten assumption. b.Simplify the derived rate equation for reaction conditions where the S1 substrate concentration is much higher than the S2 substrate concentration.
If the substrate concentration is twice the KM of an enzyme. The initial velocity (Va) is going to be of the maximum velocity (Vmax) according to Michaelis-Menten (MM) equation, Hint: Use the MM equation to arrive at the answer. O 1/2 O 1/4 O 1/3 O 2/3
14.
Protein phosphatase 1 (PP1) helps regulate cell division and is a possible drug target to treat certain types of cancer. The enzyme catalyzes the hydrolysis of a phosphate group from myelin basic protein (MBP). The activity of PP1 was measured in the presence and absence of the inhibitor phosphatidic acid (PA). [MBP] (mg-mL-¹) 0.010 0.015 0.025 0.050 Vo without PA (nmol-mL-¹ min-¹) 0.0209 0.0355 0.0419 0.0838 Use the data in the table to construct a Lineweaver-Burk plot. What type of inhibitor is phosphatidic acid? Uncompetitive Noncompetitive Mixed inhibition Competitive Vo with PA (nmol-mL-¹ min-¹) 0.00381 0.00620 0.00931 0.01400
1. What is the difference between a transition state and an intermediate?
How does Kcat influence the velocity of MM enzymes ? A. Linear relationship B. Inverse relationship C. No effect D. Only effects velocity if total enzyme concentration is low v = Vmax [S] KM + [S] Turnover rate kcat = Vmax [ET] Speed (substrates product/sec)
Attached is the basic model for an enzyme-catalyzed reaction. Assume that substrate binding is rate determining. Write the equations for the total amount of enzyme in the reaction and the rate of the reaction. Is A or B correct? If not, show work for the correct answer A : [E] = [ES] + E B : [E] = [E]0 - [ES] ; r= k2 [E]0 S / kM + [E]
What can contamination of reagents leads to? Unreliable results Reliable results Reproducible results Good results Catalase is the enzyme found in potatoes and It decomposes hydrogen peroxide (H202) to form water and oxygen gas. H202 + catalase - ----> H2O + 02 +E. The reaction is maintained at temperature 40 degree Celsius and there was a formation of bubbles. Based on the enzymatic reaction given, What do you think is the substance responsible for the formation of bubbles? Oxygen gas Hydrogen gas no reaction, because the enzyme catalase will be deactivated no reaction, because the enzyme catalase will be denatured Other: Based on the Fehling's test video, do you think the sugars ribose (in RNA) and the deoxyribose (in DNA) will both form a positive result (red precipitate) No Yes