1. A rectangular reinforced concrete beam with width of 300mm and effective depth of 600mm is subjected to a bending moment of 200 kN-m. The beam is reinforced with 4 - 32mm diameter bars. The modular ratio n = 8. Assume d' = 60 mm Determine the stresses, fcc, fct, and fs in the beam (Uncracked and Cracked Analysis)

1. A rectangular reinforced concrete beam with width of 300mm and effective depth of 600mm is subjected to a bending moment of 200 kN-m. The beam is reinforced with 4 - 32mm diameter bars. The modular ratio n = 8. Assume d' = 60 mm Determine the stresses, fcc, fct, and fs in the beam (Uncracked and Cracked Analysis)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

bb3 please help me this is my last attempt
With the reason
A pre-tensioned rectangular concrete beam 150 mm wide and 300 depth is prestressed with three straight tendons, each having a cross- sectional area of 50 mm2, to an initial stress of 1200 N/mm2. The tendons are located at 100 mm from the soffit of the beam. If the modular ratio is 6, the loss of prestressing force (in kN, up to one decimal place) due to the elastic deformation of concrete only is
Problem 3.1. A 1-in-diameter solid bar (), a square solid bar (2), and a circular tubular member with 0.2-in. wall thickness (3), cuch supports an axial tensile load of 5 kips. (a) Determine the axial stress in bar (1). (b)lf the axial stress in each of the other bars is 6 ksi, what is the dimension, b, of the square bar, and what is the outer diameter, e, of the tubular member? I in. 1=0.2 in. (1) (3)
i need the answer quickly
In the following beam system, the beam is subjected to uniform distributed load W = 25 lb /in. Assume a = 90-inch, b = 130-inch, C = 40 inch and d = 50 inch a) Determine the resultant force produced at the pin C for the distributed load, W b) What is the factor of safety that exists for pin C with respect to its fracture strength? assume that the pin at C fractures when the resultant force reaches a value 35000 lb.
N = 7
Detailed Solution please
During the tension test, the wooden specimen is subjected to an average normal stress of 2 ksi. Determine the axial force P applied to the specimen. Also, find the average shear stress developed along the section Ɵ -a of the specimen.
(1) 1d. What is the shear stress on an element with principal stresses of 565 psi and -435 psi?
answer quickly
The general stress element shown is loaded such that o = 20 MPa, oy = -20 MPa, Txy = 10 MPa. What is the max dy 1 xy 70x