1) Write your dilutions as a rational number AND in scientific format? What was your total dilution (in scientific notation)? 2) What was the original concentration of your culture if you spread 0.1 ml of d3 and counted 360 cfu?

Q: You are asked to prepare 20 mL of a 50 mg/mL drug dilution from a stog of 2 g/5 mL. How many…

A: Here, We need to calculate the milliliter of dilutant needed, for that purpose stock solution…

Q: upply a thorough yet concise description of your results for this method

A: Answer.  The given graph is between Time vs Growth measured via absorbance where the time is in…

Q: My question is: Could you explain steps? (etc. why do we heat or add chemicals like nacl or ammonium…

A: Casein is the major protein component found in milk. It is generally a phosphoprotein which is…

Q: Find the amount of dehydrated medium needed to prepare 15 BUTTS, 20 SLANTS, and 25 BUTT-SLANTS.

A: Slants, Butt-slants, and butts are different types of media prepared for bacterial growth. Slants…

Q: est tube Ascorbic acid stock (20 μg/mL) Citrate buffer Final Concentrations 1 0 μL 1000 μL…

A: In linear regression analysis, we examine whether one variable (called independent variable) can be…

Q: Provide a chemical test/reagent that would differentiate each of the following pairs of compounds.…

A: Asked : Reagent and indication of positive test

Q: 3. The following results were obtained for the analysis of phenanthrene using isotopically labeled…

A: Biomolecules are the biological molecules that are present inside the living organisms. These…

Q: 1. How many grams of dextrose will be needed in the final product? 2. How many mL of Dextrose 70%…

A: Dextrose injection is a sterile solution commonly used to provide water balance and carbohydrate to…

Q: The order is for Moxam 5 gm IM every 8 hours.  On hand is 10 gram of Moxam with the following…

A: Medication order is the terms used to define the directions for a drug needed to be given to the…

Q: 10 If 3 ml of culture is diluted by adding 9 ml of water and the absorbancy reading of the diluted…

A: Sol: Given                   Volume of the culture used = 3 ml                             Volume of…

Q: 4 mL of 10% TCA solution was added to 1 mL of serum and after mixing, it was waited for two minutes…

A: Calibration graphs are used to estimate the concentration of unknown sample by plotting it against…

Q: Pretend the results below were obtained for water from your well. The 10 mL tubes are Full Strength,…

A: Most Probable Number or MPN method is a way to estimate the number of microorganisms in the water…

Q: Calculate the amount of phycocyanin in Sample 1 in mg where A620=0.204 and A650=0.061, taking into…

A: Phycocyanin is a blue pigment found in cyanobacteria and certain algae. It is a phycobiliprotein…

Q: Order: Prochlorperazine (Compazine) 7.5 mg, PO, qid Using the following drug label, how many…

A: The objective of the question is to determine the volume of Compazine syrup the patient will receive…

Q: a)Determine the amount of X (in gram) in order to prepare 100 mL of 50 mM stock solution of X. Show…

A: In this question, we are given: a) Molecular weight of X= 225 Molarity of stock solution= 50 mM…

Q: Prepare the following using ingredients from your kitchen: Egg white from one egg Full cream milk…

A: The above given question is just a activity and the  some of our earlier knowledge . Due to question…

Q: what are the principle chemical reaction involved in each test?

A: The primary, secondary and tertiary alcohols react with hydrogen halides in a different manner and…

Q: You will be given 1 mL of a 2.0 mg/mL solution of bovine serum albumin (BSA) and 1 mL of a 2.0 mg/mL…

A: Dilution in biochemistry is used to lower and get the desired concentration of solute solution by…

Q: When conducting a flame test for sodium iodide, is the result positive or negative?

A: An ionic compound is one that is formed between a metal or metalloid and a non-metal. A Flame test…

Q: the following questions about protein concentration determination. a) At what wavelength should an…

A: Spectrophotometry is a process in which the intensity of light is measured, which determines the…

Q: can you show how to calculate the amount of two components for the required volume of a buffer with…

A: Given Values: Concentration of Tris = 0.25 M Concentration of Glycine = 1.92 M Concentration of SDS…

Q: After doing the preliminary studies on redcrest protein extract, Tighnari proceeded with its…

A: Proteins are macromolecule comprised of amino acids linked by peptide bonds which forms a primary…

Q: What does translucent spot mean with regards to lipid? Identify the control for this test.  1. Oil…

A: Introduction  Oils and fats are a reliable source of energy. A certain amount of human body weight…

Q: For his experiment, Brian needs to prepare 30 plates (use maximum volume), 15 slants (small test…

A: In order for the microorganisms to survive and grow under laboratory conditions we need to provide…

Q: The order is for Dilantin 200 mg, PO, qd. You have on hand Dilantin 250 mg per 5 ml. How many…

A: To calculate the required milliliters, we need to use the following formula: (Number of milligrams…

Q: cholesterol determination

A: Cholesterol: It is a waxy, fat like substance which is essential for the normal functioning of the…

Q: Calculate the appropriate volume (in µL) of 3X loading buffer that should be added to 24.0 µL of a…

A: Dilution factor (DF) can be expressed both as the ratio of concentrations and as ratio of volumes.…

Q: From a 50% solution of dextrose, make 500 ml of a 5% solution

A: In your role as a nurse, your objective is to ensure the safety of patients and the correct…

Q: Give three other chemical tests that can be used to characterize lipid samples (can be general or…

A: Concept introduction Lipids are one of the important biomolecules. They are organic substances…

Q: Table 2   Absorbance vs CoCl2 concentration   Test Tube Number Cobalt Chloride Concentration…

A: Spectrophotometry or colorimetry is an analytical technique that is used for the quantification of…

Q: You have a sample at 50 ng/ul and you would like to load 400ng of this sample on a lane of an…

A: Agarose gel electrophoresis is a technique to study the features of genetic material and proteins.…

Q: You have been asked to make up four 1.5% agarose gels at 30 ml each. Ethidium Bromide is to be added…

A: As you have asked multiple questions we are instructed to answer only one. Please repost the…

Q: You are to prepare capsules that contain 0.125 g of a drug. You have four partial containers of…

A: The accuracy of the weighing is hundredth of a gram meaning the accuracy is 0.01 g. This scale can…

Q: Calculate the appropriate volume (in µL) of 9X loading buffer that should be added to 46.0 µL of a…

A: Agarose gel electrophoresis is a laboratory technique that is used for the separation of nucleic…

Q: Using 10 μL of a patient's serum, how much diluent would be needed to create a 1:10 dilution? ______…

A: Dilution is the technique of lowering the concentration of a solute in a solution by merely adding…

Q: a physician prescribed an antibiotic to be mixed in white petrolatum to produce a 25% antibiotic…

A: Ointment preparations with antibiotics in petrolatum are useful for local external…

Q: How many mLs should be removed from your dextrose 70% bag?

A: Answer: The mass of dextrose present in 400 mL of solution is 280 g.

Q: 50 g of food is homogenized in 450 mL of water. From this, 1 mL is added to 29 mL of water, and then…

A: Whenever a microrganism is plated for analytical purposes, it population is reported in terms of…

Q: Where do you expect to see the highest number of CFU on a plate: Select one: a. When pasteurized…

A: The number of colony forming units on the countable plate is multiplied by 1/FDF to get the number…

Q: How do you make 70 ml of a 60% solution??

A: The making of solutions of different concentrations can be achieved with the help of principle…

Q: quick burst of energy?

A: Note : As in the questions mentioned above, the answers for 2,4,5,6,7 are already solved and there…

Q: Prepare 100mL of a 20%v/v bleach solution.      i) What is the total volume of solution wanted?…

A: A solute is a substance which dissolves in a solvent to produce a homogenous mixture that is known…