Lab 10 Answers

Question : with Eight LEDs with 74HC595. This code uses a shift register to use a single data pin to light up 8 LEDs. The code uses the command "bitSet" to set the light pattern. What is the value of the variable leds when the value of currentLED is 5? Hint: You can use Serial.begin(9600) in the setup and Serial.println(leds) in the loop to examine this value. Answer must be a numerical value

answer the following with as much detail possible   Use the following link to access the practice pdf to view the information needed to answer the questions.   labpractice00001.tiiny.site   The questions are in the following image Do proper Hand drawings.  Show hand drawn  2-to-1 multiplexer in which the inputs and outputs consist of single bits. and schematic diagram for the mux designed

Q2 C only thank you

Q2 B only thank you

The terminal count up (TCu) and terminal count down (TCd) of 74193 are normally ____ . The TCu is used to indicate that ____ count is reached.  HIGH, 9th B.LOW, 9th C. HIGH, 15th D. LOW, 15 E. LOW, maximumD. a BCD decade up/down counter E. a register

ASM with MSI Devices 1. Complete the ROM Table based on the final ASM chart shown in #1, and thecircuit diagram shown in #2.2. Complete the EPROM Programming Table based on the ROM Table.

DRAM uses a _______ to store a bit in each cell. A.transistor B.diode C.capacitor D.flip-flop

During the execution of an IN instruction, the WR* signal will ________.   A) Stay high. B) Go low. C) Tristate. D) Multiplex