5-1 lab

docx

School

Southern New Hampshire University *

*We aren’t endorsed by this school

Course

210

Subject

Electrical Engineering

Date

Jan 9, 2024

Type

docx

Pages

Uploaded by frichards55

Your work has been saved and submitted Written Nov 24, 2023 5:13 PM - Nov 24, 2023 5:34 PMAttempt 1 of 2 Auto-summarization summarizes networks according to their __________ subnet. Stateless Classful Stateful Classless Question 2 Question options: Which letter is used in the routing table to indicate that the route was learned via the RIP? B R S T Question 3 Question options: When using the show IP protocols command, which of the following is not displayed? Subnet masks Interfaces participating in RIP Attempt Score 24 / 40 - D Overall Grade (Highest Attempt) 24 / 40 - D Question 1 4 / 4 points

RIP timers Networks being routed Question 4 Question options: If your NAT has not timed out and you want to remove NAT configuration from a router, you should use what command? Set IP nat translation IP nat inside source No IP nat inside source Clear router Question 5 Question options: What is the main difference between RIPv1 and RIPv2? Question options: Version 2 has the ability to carry subnetting information. The addresses are translated in reverse order. Version 2 incorporates AES. Not all address are translated, only the one put in the routing table. Question 0 / 4

6 points Both PC1 and Server 1 have a default gateway. What is the purpose of a default gateway? Question options: To block packets To route packets to a different subnet To forward frames To route packets to the same subnet on For static NAT to work, how many inside global addresses are needed for inside local addresses? Question options: One inside global address for unlimited inside local addresses One inside global address for every inside local address Ten inside global addresses for unlimited inside local addresses Two inside global addresses for every inside local address Question 8 0 / 4 points

Your preview ends here

Eager to read complete document? Join bartleby learn and gain access to the full version

Access to all documents
Unlimited textbook solutions
24/7 expert homework help

What factors are used to calculate the OSPF cost? Bandwidth Bandwidth, delay Bandwidth, MTU Delay Question 9 Question options: Which of the following is a distance-vector routing protocol that uses a metric of hops? IS-IS RIP OSPF EIGRP Question 10 Question options: At the moment, PC1 cannot reach the internet. You add a static default route to R1 that sends all traffic to an unknown destination out S1/1. Can a user on PC1 access the internet?

No. The packets will not make it past R1. Yes. PC1 has internet access. No. The packets can make it to the internet, but they will never make it back to PC1. No. The packets will stop at R2. Question options: Done