The methods to measure the equilibrium vapour pressure of a liquid has to be explained. Concept Introduction: A liquid in an open vessel evaporates completely with the help of air and diffusion take away most of the gas phase molecules before they condense. There is not an equilibrium between vaporization and condensation. On the other hand, a liquid in a sealed vessel slowly evaporates as the gas phase molecules can’t escape. When the rate of condensation equals to the rate of vaporization a dynamic equilibrium is established. The pressure of the vapour at this equilibrium is called vapour pressure of that liquid.

Question

Want to see the full answer?

Answer 1

Question

Chapter 9, Problem 3QRT

Interpretation Introduction

Interpretation:

The methods to measure the equilibrium vapour pressure of a liquid has to be explained.

Concept Introduction:

A liquid in an open vessel evaporates completely with the help of air and diffusion take away most of the gas phase molecules before they condense. There is not an equilibrium between vaporization and condensation.

On the other hand, a liquid in a sealed vessel slowly evaporates as the gas phase molecules can’t escape. When the rate of condensation equals to the rate of vaporization a dynamic equilibrium is established. The pressure of the vapour at this equilibrium is called vapour pressure of that liquid.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

My question is whether HI adds to both double bonds, and if it doesn't, why not?

Strain Energy for Alkanes Interaction / Compound kJ/mol kcal/mol H: H eclipsing 4.0 1.0 H: CH3 eclipsing 5.8 1.4 CH3 CH3 eclipsing 11.0 2.6 gauche butane 3.8 0.9 cyclopropane 115 27.5 cyclobutane 110 26.3 cyclopentane 26.0 6.2 cycloheptane 26.2 6.3 cyclooctane 40.5 9.7 (Calculate your answer to the nearest 0.1 energy unit, and be sure to specify units, kJ/mol or kcal/mol. The answer is case sensitive.) H. H Previous Next

A certain half-reaction has a standard reduction potential Ered +1.26 V. An engineer proposes using this half-reaction at the anode of a galvanic cell that must provide at least 1.10 V of electrical power. The cell will operate under standard conditions. Note for advanced students: assume the engineer requires this half-reaction to happen at the anode of the cell. Is there a minimum standard reduction potential that the half-reaction used at the cathode of this cell can have? If so, check the "yes" box and calculate the minimum. Round your answer to 2 decimal places. If there is no lower limit, check the "no" box.. Is there a maximum standard reduction potential that the half-reaction used at the cathode of this cell can have? If so, check the "yes" box and calculate the maximum. Round your answer to 2 decimal places. If there is no upper limit, check the "no" box. yes, there is a minimum. 1 red Πν no minimum Oyes, there is a maximum. 0 E red Dv By using the information in the ALEKS…