The ceramic material that are currently used for cutting tool application. The features that make the material attractive.

Question

Want to see the full answer?

Answer 1

Question

Chapter 8, Problem 76RQ

To determine

The ceramic material that are currently used for cutting tool application.

The features that make the material attractive.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

1- Ceramic matrix composites are designed to overcome which of the following weaknesses of ceramics (two best answers): (a) compressive strength, (b) hardness, (c) hot hardness, (d) modulus of elasticity, (e) tensile strength, and (f) toughness? 2- A facing operation is normally performed on which of the following machine tools (one best answer)? (a) drill press, (b) lathe, (c) milling machine, (d) planer. 3- A cylindrical workpart 125 mm in diameter and 900 mm long is to be turned in an engine lathe. Cutting conditions are: v = 2.5 m/s, f= 0.3 mm/rev, and d = 2.0 mm. The (a) cutting time, and (b) metal removal rate are: a) 7.18 min and 1400 mm3/s 7.85 min and 1500 mm/s b) 7.85 min and 1700 mm3/s c) 7.00 min and 1500 mm/s d) 4- Which of the following materials are not composites. (d) Portland cement, (a) cemented carbide, (e) rubber in automobile tires, (b) phenolic molding compound, (c) plywood, and (f) wood? 5- Which one of the following manufacturing processes will likely result in…

8. What are some of the general properties that distinguish metals from ceramics and polymers?

"Your boss requests a recommendation on which process to use to make fillet welds on stainless steel rail tank cars with this material. Your heart beating fast, you respond. " A: Use HYPERFILL®. The cooling rate is acceptable for this material and productivity gains are important given the large size of the product. B: "Use HYPERFILL®, for the same reasons as (A), BUT we need to change materials to a low carbon stainless steel (e.g. 304L) or we will get corrosion failure in the HAZ." C: "Use GMAW-P. For this material, this heat input is best. " D: "Use GMAW-P, for the same reasons as (C), but we need to change materials to a low carbon stainless steel (e.g. 304L) or we will get corrosion failure in the FZ."