The compound that produce the bright light in the conductance apparatus should be identified. Concept Introduction: Conductivity of electricity is a physical property which is typical of species when dissolved in solution, typically, in an aqueous solution. If the material dissolves properly in water, and conduces electricity, then this is said to be a strong electrolyte. A material which dissolves and only conduces a small amount, will be considered a weak electrolyte. A material which will not conduct electricity at all is considered a nonelectrolyte. Note that sucrose is not even an electrolyte, so ignore it, as it will not conduct electricity.

Question

Calculate the concentration in % (w/w) of the following solutions. Assume water has a density of 1.00 g/mL. a. 5.4 g of sugar and 1.50 x 102 mL of water Concentration = % (w/w) b. 4.2 g of any solute Concentration = -assignment-take and 2.50 x 10² mL of water % (w/w) c. 5.1 g of any solute and 2.00 x 10² g of any solvent Concentration = % (w/w) Submit Answer Retry Entire Group 2 more group attempts remaining Previous Email Instructor

Answer 1

Question

Chapter 6, Problem 6.58P

Interpretation Introduction

Interpretation:

The compound that produce the bright light in the conductance apparatus should be identified.

Concept Introduction:

Conductivity of electricity is a physical property which is typical of species when dissolved in solution, typically, in an aqueous solution.

If the material dissolves properly in water, and conduces electricity, then this is said to be a strong electrolyte.

A material which dissolves and only conduces a small amount, will be considered a weak electrolyte.

A material which will not conduct electricity at all is considered a nonelectrolyte.

Note that sucrose is not even an electrolyte, so ignore it, as it will not conduct electricity.

Expert Solution & Answer

Trending nowThis is a popular solution!

See solution

Check out sample textbook solution

Students have asked these similar questions

Calculate the concentration in % (w/w) of the following solutions. Assume water has a density of 1.00 g/mL. a. 5.4 g of sugar and 1.50 x 102 mL of water Concentration = % (w/w) b. 4.2 g of any solute Concentration = -assignment-take and 2.50 x 10² mL of water % (w/w) c. 5.1 g of any solute and 2.00 x 10² g of any solvent Concentration = % (w/w) Submit Answer Retry Entire Group 2 more group attempts remaining Previous Email Instructor

0180328145532 O Page view A Read aloud V Draw PART B Specify which of the following criteria should be met by a good solvent for a recrystallisation by marking yes (Y) or no (N). 1. (a)Solutes should bo soluble in cold solvent. (b) Solvents should not react chemically with the solvent. (c) Solvents should be polar rather than non-polar. (d) Boiling point of solvent should be above 1000°C. (e) Boiling point of the solvent should ideally be below the melting point of the solute begun purified.

(a) What is the percentage concentration of a 1:10,000 solution of epinephrine HCl (MW 219.20)? (b) If 50 mL of this solution was prepared, what would be the molarity (M)? (c) What is the milligram per deciliter concentration?