The conclusion about the homogeneity of the distillate in the fractional distillation of ethanol-water mixture should be determined. Also, whether the mixture has a constant boiling point or not and is pure compound or not is to be determined. Concept introduction: The fractional distillation is a technique that is used to separate various components or fractions from a mixture on the basis of their volatilities. The fractional distillation can be used if the boiling point difference between the components is less than 75 ° C . Fractional distillation is better than the simple distillation due to the low boiling point range. It is used to separate useful substances from crude oil in oil refineries. A mixture with uniform composition and properties throughout is called homogenous mixture.

Question

Want to see the full answer?

Answer 1

Question

Chapter 5, Problem 4Q

Interpretation Introduction

Interpretation:

The conclusion about the homogeneity of the distillate in the fractional distillation of ethanol-water mixture should be determined. Also, whether the mixture has a constant boiling point or not and is pure compound or not is to be determined.

Concept introduction:

The fractional distillation is a technique that is used to separate various components or fractions from a mixture on the basis of their volatilities. The fractional distillation can be used if the boiling point difference between the components is less than 75 °C. Fractional distillation is better than the simple distillation due to the low boiling point range. It is used to separate useful substances from crude oil in oil refineries.

A mixture with uniform composition and properties throughout is called homogenous mixture.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Don't used hand raiting

at 32.0 °C? What is the osmotic pressure (in atm) of a 1.46 M aqueous solution of urea [(NH2), CO] at 3 Round your answer to 3 significant digits.

Reagan is doing an atomic absorption experiment that requires a set of zinc standards in the 0.4-1.6 ppm range. A 1000 ppm Zn solution was prepared by dissolving the necessary amount of solid Zn(NO3)2 in water. The standards can be prepared by diluting the 1000 ppm Zn solution. Table 1 shows one possible set of serial dilutions (stepwise dilution of a solution) that Reagan could perform to make the necessary standards. Solution A was prepared by diluting 5.00 ml of the 1000 ppm Zn standard to 50.00 ml. Solutions C-E are called "calibration standards" because they will be used to calibrate the atomic absorption spectrometer. a. Compare the solution concentrations expressed as ppm Zn and ppm Zn(NO3)2. Compare the concentrations expressed as M Zn and M Zn(NO3)2 - Which units allow easy conversion between chemical species (e.g. Zn and Zn(NO3)2)? - Which units express concentrations in numbers with easily expressed magnitudes? - Suppose you have an analyte for which you don't know the molar…